Governor Actuator
Usage:
Remove And Install Governor Actuator
1. Disconnect wiring harness (1) and rod assembly (2).
2. Remove two nuts (4) and governor actuator (3).
NOTE: The following steps are for installation of the governor actuator.
3. If studs (5) are bent or damaged, make a replacement of the studs and tighten the studs to a torque of 15 ± 5 N·m (10 ± 4 lb ft).
4. Put the gasket and governor actuator (3) in position on the studs. Make sure the splines of the actuator shaft are correctly engaged with the splines of the governor drive coupling and install nuts (4).
5. Connect wiring harness (1) and rod assembly (2).
Caterpillar Information System:
3500 GENERATOR SET ENGINES Exhaust Manifold
3500 GENERATOR SET ENGINES Air Inlet Manifold
3500 GENERATOR SET ENGINES Aftercooler
3500 GENERATOR SET ENGINES Exhaust Elbow
3500 GENERATOR SET ENGINES Turbochargers
3500 GENERATOR SET ENGINES Oil Cooler
3500 GENERATOR SET ENGINES Oil Pan
3500 GENERATOR SET ENGINES Oil Filter Base
3500 GENERATOR SET ENGINES Oil Pump
3500 GENERATOR SET ENGINES Fuel Transfer Pump
3500 GENERATOR SET ENGINES Fuel Filter Base
3500 GENERATOR SET ENGINES Water Pump
3500 GENERATOR SET ENGINES Governor Actuator Drive
3500 GENERATOR SET ENGINES Governor Fastener Group
3500 GENERATOR SET ENGINES Accessory Drive (Front)
3500 GENERATOR SET ENGINES Oil And Water Pump Drive
3500 GENERATOR SET ENGINES Crankshaft Vibration Damper
3500 GENERATOR SET ENGINES Crankshaft Front Seal And Wear Sleeve
3500 GENERATOR SET ENGINES Front Drive Housing
3500 GENERATOR SET ENGINES Flywheel
3500 GENERATOR SET ENGINES Crankshaft Rear Seal And Wear Sleeve
3500 GENERATOR SET ENGINES Flywheel Housing
3500 GENERATOR SET ENGINES Oil Sequence Valves
3500 GENERATOR SET ENGINES Valve Covers