Usage:
Start By:
a. remove cylinder head assembly
1. Remove gasket (4), seals (1), seals (2) and O-ring seal (3) from the spacer plate.
2. Remove spacer plate (5) from the dowels in the cylinder block.
3. Remove gasket (6) from the dowels.
4. Remove the O-ring seal from around dowel (7).
NOTE: The following steps are for installation of the spacer plate.
5. Make sure the spacer plate and the machined surface of the cylinder block are clean and free of dirt and foreign material.
6. Install the O-ring seal around dowel (7).
NOTICE |
---|
Both surfaces of the spacer plate gasket and the top of the cylinder block must be clean. Do not use a gasket adhesive on these surfaces. |
7. Install new spacer plate gasket (6) over the dowels in the cylinder block.
8. Install spacer plate (5) on the dowels.
9. Install O-ring seal (3) around dowel (7).
10. Install new water seals (1) and (2) in spacer plate (5).
11. Check the cylinder liner projection. See Install Cylinder Liners.
12. Install new cylinder head gasket (4) on the spacer plate.
End By:
a. install cylinder head assembly