Inlet Air Temperature Sensor - Remove and Install
Show/hide table
PERHATIAN |
---|
Pastikan semua suku cadang bersih dari kontaminan. Kontaminan dapat menyebabkan keausan yang cepat dan mempersingkat umur komponen. |
- Putuskan susunan rangkaian kabel (2).
- Lepaskan sensor temperatur udara masuk (1) dari manifold masuk.
- Lepaskan seal O-ring dari sensor temperatur udara masuk (1).
Show/hide table
Ilustrasi 1 | g01151116 |
Show/hide table
PERHATIAN |
---|
Pastikan semua suku cadang bersih dari kontaminan. Kontaminan dapat menyebabkan keausan yang cepat dan mempersingkat umur komponen. |
- Pasang seal O-ring baru pada sensor temperatur udara masuk (1).
- Pasang sensor temperatur udara masuk (1) ke manifold masuk dan kencangkan dengan torsi
20 ± 5 N·m (15± 4 lb ft) . - Sambungkan susunan rangkaian kabel (2).
Show/hide table
Ilustrasi 2 | g01151116 |
Caterpillar Information System:
C9 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C9 Generator Set Engines Flywheel Housing
2005/05/02 Improved Turbochargers are Available {1052}
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
C3.3 and C4.4 Generator Sets Additional Messages
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Water Pump - Install
C27 and C32 Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
854K Wheel Dozer and 992K Wheel Loader Alternator - Remove and Install
854K Wheel Dozer and 992K Wheel Loader Electric Starting Motor - Remove and Install
C9 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C9 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C9 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
C9 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C9 Engines for Caterpillar Built Machines Front Cover - Remove
3512C Engine Product Description
2005/03/28 Engine Rerate Procedure {1000}