Engine Oil Filter Base - Disassemble
拆解步骤
开始:
- 拆下发动机机油滤清器座。 请参阅拆解和组装, "发动机机油滤清器座和机油冷却器 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从发动机机油滤清器座 (6) 上拆下弯头 (1) 和 O 形密封圈 (3) 。
Show/hide table
图 1 | g01151723 |
Show/hide table
被弹簧力爆出的零件击中,会招致人员伤害。 确保穿上所有必要的保护装备。 遵照建议的程序,并使用所有建议的工具以释放弹簧力。 |
- 从发动机机油滤清器座 (6) 拆下螺塞 (2) 和 O 形密封圈。
- 从发动机机油滤清器座 (6) 上拆下弹簧 (4) 和阀 (5) 。
- 从发动机机油滤清器座 (6) 拆下螺塞 (9) 和 O 形密封圈。
- 从发动机机油滤清器座 (6) 上拆下弹簧 (8) 和阀 (7) 。
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C9 Generator Set Engines Flywheel Housing
2005/05/02 Improved Turbochargers are Available {1052}
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
C3.3 and C4.4 Generator Sets Additional Messages
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
3126B Marine Engines CID 0127 FMI 04 Transmission Oil Pressure short to ground
3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
C9 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Water Pump - Install
C27 and C32 Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
854K Wheel Dozer and 992K Wheel Loader Alternator - Remove and Install
854K Wheel Dozer and 992K Wheel Loader Electric Starting Motor - Remove and Install
C9 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C9 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C9 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove