3126B Marine Engines Caterpillar


CID 0127 FMI 04 Transmission Oil Pressure short to ground

Usage:

3126B 3GS
Conditions Which Generate This Code:

The signal from the marine transmission oil pressure sensor is below normal.

System Response:

The Electronic Control Module (ECM) will log the diagnostic code. The ECM flags marine transmission oil pressure as invalid data and a default value is used.

  • There are no performance effects.

Test Step 1. Perform the following diagnostic procedure: Engine Pressure Sensor Open or Short Circuit - Test

Results:

  • OK - STOP

Caterpillar Information System:

3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
Cleaning the Engine Mounted Heat Exchanger{1379} Cleaning the Engine Mounted Heat Exchanger{1379}
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3126B Industrial Engines CID 0094 FMI 03 Fuel Pressure open/short to +batt
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
C27 and C32 Generator Set Engines Crankshaft Position Sensor - Remove and Install
C7 and C9 Marine Engines Diagnostic Code Cross Reference
C27 and C32 Generator Set Engines Camshaft Position Sensor - Remove and Install
3406C Marine Auxiliary Generator Set Control Panel
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
2005/03/14 A New Engine Oil is Used for the Factory Fill in Gas Engines {1348}
C9 Engines for Caterpillar Built Machines Turbocharger - Install
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C3.3 and C4.4 Generator Sets Additional Messages
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
2005/05/02 Improved Turbochargers are Available {1052}
C9 Generator Set Engines Flywheel Housing
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C9 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.