Engine Oil Filter Base and Oil Cooler - Remove
拆卸步骤
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件说明 | 数量 |
| A | 185-3630 | 带式扳手组件 | 1 |
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
| 注意 |
|---|
在检验、保养、测试、调整及维修产品时，务必留心，确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前，要准备好用合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上液体的工具及用品，参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。 按照当地法规和指令处置所有液体。 |
- 使用工具 (A) ，拆下发动机机油滤清器 (1) 。
Show/hide table
 | |
| 图 1 | g01150737 |
- 断开软管组件 (2) 。 拆下螺栓 (3) 。 拆卸发动机机油滤清器座 (4) 和油封。
Show/hide table
 | |
| 图 2 | g01150959 |
- 拆下发动机机油冷却器 (5) 。
Show/hide table
 | |
| 图 3 | g01150963 |
Caterpillar Information System:
C27 and C32 Generator Set Engines Crankshaft Position Sensor - Remove and Install
C7 and C9 Marine Engines Diagnostic Code Cross Reference
C27 and C32 Generator Set Engines Camshaft Position Sensor - Remove and Install
3406C Marine Auxiliary Generator Set Control Panel
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
2005/03/14 A New Engine Oil is Used for the Factory Fill in Gas Engines {1348}
C9 Engines for Caterpillar Built Machines Turbocharger - Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Quick Coupler - Lubricate - If Equipped
D Series Excavator Monitoring System Password Entry
C9 Engines for Caterpillar Built Machines Turbocharger - Remove
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Install
C9 Generator Set Engines Engine Oil Pan
3126B Industrial Engines CID 0094 FMI 03 Fuel Pressure open/short to +batt
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
Cleaning the Engine Mounted Heat Exchanger{1379} Cleaning the Engine Mounted Heat Exchanger{1379}
3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
3126B Marine Engines CID 0127 FMI 04 Transmission Oil Pressure short to ground
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C3.3 and C4.4 Generator Sets Additional Messages
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install