C7 and C9 Marine Engines Caterpillar


Diagnostic Code Cross Reference

Usage:

C7 C7D
Problems with the electronic control system are reported via these types of codes: flash codes, SPN/FMI codes, diagnostic codes, and event codes.

For information on flash codes, refer to troubleshooting with a diagnostic code Troubleshooting, "Flash Codes".

For information on SPN/FMI codes, refer to troubleshooting with a diagnostic code Troubleshooting, "Diagnostic Codes".

For information on diagnostic codes, refer to troubleshooting with a diagnostic code Troubleshooting, "Diagnostic Codes".

For information on event codes, refer to troubleshooting with an event code Troubleshooting, "Event Codes".

Cross-Reference for Flash Code to SPN-FMI Code to CID-FMI (Diagnostics) or EID (Events)

Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.

Table 1
Cross-Reference for Flash Code to SPN-FMI Code to CID-FMI (Diagnostics) or EID (Events) 
Flash Code  SPN-FMI or EID  CID-FMI or EID  Description of Code 
13  174-03  174-03  Fuel Temperature open/short to +batt 
174-04 174-04  Fuel Temperature short to ground 
17  168-00  168-00  System Voltage High 
168-01 168-01  System Voltage Low 
168-02 168-02  System Voltage intermittent/erratic 
21  620-03  262-03  5 Volt Sensor DC Power Supply short to +batt 
620-04 262-04  5 Volt Sensor DC Power Supply short to ground 
678-03 263-03  Digital Sensor Supply short to +batt 
678-04 263-04  Digital Sensor Supply short to ground 
24  100-03  100-03  Engine Oil Pressure open/short to +batt 
100-04 100-04  Engine Oil Pressure short to ground 
25  102-03  102-03  Boost Pressure Sensor short to +batt 
102-04 102-04  Boost Pressure Sensor short to ground 
27  110-03  110-03  Engine Coolant Temperature open/short to +batt 
110-04 110-04  Engine Coolant Temperature short to ground 
28  91-13  91-13  Throttle Position Calibration required 
29-13 1249-13  Secondary Throttle Position calibration required 
32  91-08  91-08  Throttle Position signal abnormal 
29-08 1249-08  Secondary Throttle Position signal abnormal 
34  190-11  190-11  Engine Speed Sensor mechanical failure 
723-11 342-11  Secondary Engine Speed Sensor mechanical failure 
35  190-00  E190  Engine Overspeed Warning 
37  94-03  94-03  Fuel Pressure open/short to +batt 
94-04 94-04  Fuel Pressure short to ground 
38  172-03  105-03  Inlet Manifold Temp Sensor open/short to +batt 
172-04 105-04  Inlet Manifold Temp Sensor short to ground 
42  228-13  261-13  Engine Timing Calibration required 
46  100-18  E039  Low Engine Oil Pressure Derate 
100-17 E100  Low Engine Oil Pressure Warning 
53  N/A  254-12  Electronic Control Module Error 
56  111-02  268-02  Check Programmable Parameters 
58  111-18  E057  Low Engine Coolant Level Derate 
111-17 E059  Low Engine Coolant Level Warning 
59  253-02  253-02  Personality Module mismatch 
61  111-16  E015  High Engine Coolant Temperature Derate 
111-15 E017  High Engine Coolant Temperature Warning 
63  94-07  E053  Low Fuel Pressure Warning 
94-15 E096  High Fuel Pressure 
64  172-16  E025  High Inlet Air Temperature Derate 
172-015 E027  High Inlet Air Temperature Warning 
65  174-15  E056  High Fuel Temperature Warning 
66  177-15  E030  High Transmission Oil Temperature Warning 
67  177-03  177-03  Transmission Oil Temperature open/short to +batt 
177-04 177-04  Transmission Oil Temperature short to ground 
68  127-03  127-03  Transmission Oil Pressure open/short to +batt 
127-04 127-04  Transmission Oil Pressure short to ground 
69  127-15  E113  High Transmission Oil Pressure 
71  651-11  1-11  Cylinder #1 Injector fault 
72  652-11  2-11  Cylinder #2 Injector fault 
73  653-11  3-11  Cylinder #3 Injector fault 
74  654-11  4-11  Cylinder #4 Injector fault 
75  655-11  5-11  Cylinder #5 Injector fault 
76  656-11  6-11  Cylinder #6 Injector fault 
137  164-00  164-00  High Injector Actuation Pressure 
164-02 164-02  Injector Actuation Pressure signal erratic 
164-03 164-03  Injector Actuation Pressure voltage high 
164-04 164-04  Injector Actuation Pressure voltage low 
164-11 164-11  Injector Actuation Pressure system fault 
138  679-11  42-11  Inject Actuation Control Valve open/short 
185  173-18  535-08  Exhaust Temperature Sensor noisy signal 
49  729-05  617-05  Air Inlet Heater Relay open/current below normal 
729-06 617-06  Air Inlet Heater Relay grounded/current above norm 
N/A  96-17  E119  Low Fuel Level 
N/A  N/A  E173  High Exhaust Temperature Warning 

Caterpillar Information System:

C27 and C32 Generator Set Engines Camshaft Position Sensor - Remove and Install
3406C Marine Auxiliary Generator Set Control Panel
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
2005/03/14 A New Engine Oil is Used for the Factory Fill in Gas Engines {1348}
C9 Engines for Caterpillar Built Machines Turbocharger - Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Quick Coupler - Lubricate - If Equipped
D Series Excavator Monitoring System Password Entry
C9 Engines for Caterpillar Built Machines Turbocharger - Remove
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Install
C9 Generator Set Engines Engine Oil Pan
C27 and C32 Generator Set Engines Crankshaft - Install
C3.3 and C4.4 Generator Sets Fuel System Secondary Filter - Replace
C27 and C32 Generator Set Engines Crankshaft Position Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
3126B Industrial Engines CID 0094 FMI 03 Fuel Pressure open/short to +batt
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
Cleaning the Engine Mounted Heat Exchanger{1379} Cleaning the Engine Mounted Heat Exchanger{1379}
3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
3126B Marine Engines CID 0127 FMI 04 Transmission Oil Pressure short to ground
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.