CID 1249 FMI 08 Secondary Throttle Position signal abnormal
Conditions Which Generate This Code:
The frequency or the duty cycle of the signal from the secondary throttle input is incorrect.
System Response:
The Electronic Control Module (ECM) will log the diagnostic code. The ECM flags the throttle position as invalid data and a default value is used.
- The engine speed is limited to low idle.
Test Step 1. Perform the following diagnostic procedure: Throttle Position Sensor Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
3126B Marine Engines CID 0127 FMI 04 Transmission Oil Pressure short to ground
3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
Cleaning the Engine Mounted Heat Exchanger{1379} Cleaning the Engine Mounted Heat Exchanger{1379}
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3126B Industrial Engines CID 0094 FMI 03 Fuel Pressure open/short to +batt
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
C27 and C32 Generator Set Engines Crankshaft Position Sensor - Remove and Install
C7 and C9 Marine Engines Diagnostic Code Cross Reference
C27 and C32 Generator Set Engines Camshaft Position Sensor - Remove and Install
3406C Marine Auxiliary Generator Set Control Panel
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C3.3 and C4.4 Generator Sets Additional Messages
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
2005/05/02 Improved Turbochargers are Available {1052}
C9 Generator Set Engines Flywheel Housing
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C9 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install