CID 0094 FMI 03 Fuel Pressure open/short to +batt
Conditions Which Generate This Code:
The signal voltage from the fuel pressure sensor is above normal.
System Response:
The Electronic Control Module (ECM) will log the diagnostic code. The ECM flags fuel pressure as invalid data and a default value is used.
Test Step 1. Perform the following diagnostic procedure: Analog Sensor Open or Short Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
C27 and C32 Generator Set Engines Crankshaft Position Sensor - Remove and Install
C7 and C9 Marine Engines Diagnostic Code Cross Reference
C27 and C32 Generator Set Engines Camshaft Position Sensor - Remove and Install
3406C Marine Auxiliary Generator Set Control Panel
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
2005/03/14 A New Engine Oil is Used for the Factory Fill in Gas Engines {1348}
C9 Engines for Caterpillar Built Machines Turbocharger - Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Quick Coupler - Lubricate - If Equipped
D Series Excavator Monitoring System Password Entry
C9 Engines for Caterpillar Built Machines Turbocharger - Remove
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Install
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
Cleaning the Engine Mounted Heat Exchanger{1379} Cleaning the Engine Mounted Heat Exchanger{1379}
3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
3126B Marine Engines CID 0127 FMI 04 Transmission Oil Pressure short to ground
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C3.3 and C4.4 Generator Sets Additional Messages
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
2005/05/02 Improved Turbochargers are Available {1052}