Engine Oil Filter Base and Oil Cooler - Install
安装步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 安装发动机机油冷却器 (5) 。
Show/hide table
 | |
| 图 1 | g01150963 |
- 在油封上涂抹清洁的发动机机油。 在发动机机油滤清器座 (4) 中安装油封。 在发动机机油冷却器上方定位发动机机油滤清器座 (4) 。 安装螺栓 (3) 。 连接管组件 (2) 。
Show/hide table
 | |
| 图 2 | g01150959 |
- 安装发动机机滤清器 (1) 。
Show/hide table
 | |
| 图 3 | g01150737 |
- 向发动机加注机油到正确的油位。 请参阅操作和保养手册, "加注容量和建议"。
Caterpillar Information System:
C3.3 and C4.4 Generator Sets Additional Messages
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
2005/03/21 The MIDS Display is Replaced by the Advisor Monitor Display {7490}
C7 and C9 Marine Engines CID 1249 FMI 08 Secondary Throttle Position signal abnormal
C7 and C9 Marine Engines CID 0164 FMI 11 Injector Actuation Pressure system fault
3126B Industrial Engines CID 0164 FMI 04 Injector Actuation Pressure voltage low
3126B Marine Engines CID 0127 FMI 04 Transmission Oil Pressure short to ground
3126B Marine Engines CID 0127 FMI 03 Transmission Oil Pressure open/short to +batt
Cleaning the Engine Mounted Heat Exchanger{1379} Cleaning the Engine Mounted Heat Exchanger{1379}
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3126B Industrial Engines CID 0094 FMI 03 Fuel Pressure open/short to +batt
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
2005/05/02 Improved Turbochargers are Available {1052}
C9 Generator Set Engines Flywheel Housing
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C9 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
C9 Engines for Caterpillar Built Machines Water Pump - Install
C27 and C32 Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
854K Wheel Dozer and 992K Wheel Loader Alternator - Remove and Install