Shutoff Valve (Ventilation System)
Show/hide table
Illustration 1 | g01057295 |
Tighten the connectors to the following torque. ... 47.5 ± 5.5 N·m (35 ± 4 lb ft)
Maximum operating pressure ... 34450 kPa (4996 psi)
Rated flow ... 19 L/min (5 US gpm)
Caterpillar Information System:
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Cut Off Shoe Installation
550 Wheel Harvester, 570 Wheel Harvester and 580 Wheel Harvester Power Train Traction Control System
CB-535B Vibratory Compactor Vibratory System Relief Valve (Pressure Override) - Test and Adjust
725 and 730 Articulated Trucks Hoist, Steering, and Brake System Breather - Inspect/Replace
2000/03/13 Serviceable Parts of the Fuel Injection Pump {1251, 1251}
988G Wheel Loader Power Train Differential and Bevel Gear - Install - Rear
824G Wheel Dozer, 825G Soil Compactor and 826G Landfill Compactor Hydraulic System Vane Pump (Implement)
2000/05/01 New Axle Housings Increase the Parts' Commonality {3259, 3260, 3278}
725 and 730 Articulated Trucks Oscillating Hitch - Lubricate
Installation of the 172-9321 Metering Pump for the Steering System{4312} Installation of the 172-9321 Metering Pump for the Steering System{4312}
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ Switch Circuits
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Before Paving Setup
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Sensors
3408E and 3412E Engines for Caterpillar Built Machines Camshaft Bearings - Remove
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Senders
988G Wheel Loader Power Train Differential and Bevel Gear - Assemble
725 and 730 Articulated Trucks Hoist, Steering, and Brake System Oil Level - Check
140H and 160H Motor Graders Cutting Edges and End Bits - Inspect/Replace
2006/03/27 The Differential and Bevel Gear Group Has Been Updated {3251, 3258}
CS-431C, CP-433C and CS-433C Vibratory Compactors Propel System Wheel and Tire
725 and 730 Articulated Trucks Fuses - Replace
216, 226 and 228 Skid Steer Loaders Engine Supplement Muffler - Remove and Install
120H Motor Grader Cutting Edges and End Bits - Inspect/Replace
3408E and 3412E Engines for Caterpillar Built Machines Camshaft Bearings - Install