Position Sensor (Truck Body) - Adjust
Show/hide table
图 1 | g00504968 |
(1) 杆端 (2) 螺母 (3) 杆 |
注: 必须正确调整卡车车斗位置传感器,以便升起卡车车斗时档位限制能正常操作。 另外,卡车车斗位置传感器用于控制举倾控制阀的急停位置。
杆端中心之间的距离必须达到 360.0 ± 3.0 mm (14.17 ± 0.12 in)。
连杆的调整
- 从卡车车斗上断开连杆 (3) 。
- 松开连杆 (3) 上的螺母 (2) 。
- 调整连杆端 (1) 使杆端中心之间的距离达到 360.0 ± 3.0 mm (14.17 ± 0.12 in)。
- 拧紧螺母 (2) 。
- 将连杆 (3) 重新接合到卡车车斗上。
Caterpillar Information System:
793C and 793C XQ Off-Highway Trucks Hydraulic System Position Sensor (Dump Body)
773D Off-Highway Truck and 775D Quarry Truck Air System and Brakes Service and Parking Brake (Rear)
Caterpillar Monitoring System Charging System Display Mode
527 Track-Type Skidder Power Train Final Drive
3406E and 3456 Generator Set Engines Fan Drive - Install
3406E On-Highway Engine Fan Drive - Remove
D250E Series II and D300E Series II Articulated Trucks Machine Systems Rear Axle Stabilizer Rod - Remove and Install
3406E On-Highway Engine Fan Drive - Assemble
980G Wheel Loader Power Train Trunnion Support (Oscillating Axle, Rear) - Remove and Install
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0808 FMI 09 Interface Module (No. 8) Abnormal Update - Test
3304B and 3306B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0807 FMI 09 Interface Module (No. 7) Abnormal Update - Test
527 Track-Type Skidder Power Train Transmission Oil Pump
784C and 785C Off-Highway Trucks Machine Systems Valve (Suspension Cylinder Charging) - Install
793C and 793C XQ Off-Highway Trucks Hydraulic System General Information
572R Pipelayer Engine Supplement Precleaner - Remove and Install
572R Pipelayer Engine Supplement Air Cleaner - Remove and Install
572R Pipelayer Engine Supplement Turbocharger - Remove and Install
D7R Track-Type Tractor Engine Supplement Fan Drive - Disassemble
D7R Track-Type Tractor Engine Supplement Fan Drive - Assemble
416C, 426C, 428C, 436C and 438C Backhoe Loaders Hydraulic and Steering System Stabilizer Cylinders
3406E On-Highway Engine Coolant Temperature Sensor - Remove and Install
D250E Series II and D300E Series II Articulated Trucks Machine Systems Center Axle Stabilizer Rod - Remove and Install
527 Track-Type Skidder Power Train Testing and Adjusting