Fuel Filter May Leak on Certain 3406, 3412, C9, C9.3, C13, C15, and C18Engines {1260, 1261, 1262} Caterpillar


Fuel Filter May Leak on Certain 3406, 3412, C9, C9.3, C13, C15, and C18Engines {1260, 1261, 1262}

Usage:

730C2 2L7
Articulated Truck
730C (S/N: TFF1-UP)
730C2 (S/N: 2T41-UP; 2L71-UP)
745C (S/N: TFK1-UP)
Electric Power Generation
C13GENSET (S/N: DH41-UP)
Engine
3412 (S/N: 38S1-UP)
C13 (S/N: N3F1-UP)
C15 (S/N: KRA1-UP; N5F1-UP)
C18 (S/N: JLE1-UP)
Excavator
336E (S/N: YCE1-UP)
336F (S/N: TZA1-UP; RKB1-UP; LTP1-UP; WTZ1-UP)
349E (S/N: RGH1-UP)
349F (S/N: BZ21-UP; HPD1-UP)
352F (S/N: NDC1-UP; YEG1-UP; A9J1-UP)
374F (S/N: DNM1-UP)
Generator Set
3406C GEN SET (S/N: C2G1-UP)
C15 GEN SET (S/N: T4A1-UP; C5L1-UP; NAP1-UP)
C18 GEN SET (S/N: LNB1-UP; L8D1-UP; NKM1-UP)
Industrial Engine
C9 INDUSTRIAL (S/N: REH1-UP)
C9.3 (S/N: D9N1-UP)
Motor Grader
120K (S/N: SZN1-UP)
120K Series 2 (S/N: SZS1-UP)
12K (S/N: JJA1-UP)
Off-Highway Truck/Tractor
770G (S/N: KDH1-UP; ECM1-UP)
772G (S/N: KEX1-UP)
Track-Type Tractor
D6N (S/N: LJR1-UP)
D6T (S/N: SMC1-UP; RAD1-UP; KMR1-UP; GCT1-UP; SGT1-UP; HTZ1-UP)
D8R (S/N: 9EM1-UP)
D8T (S/N: J8B1-UP; FMC1-UP)
D9T (S/N: RJS1-UP)
Wheel Loader
950H (S/N: MXL1-UP)
962H (S/N: SSA1-UP)
966H (S/N: BJ61-UP; BS61-UP)
980M (S/N: KRS1-UP)
982M (S/N: F9A1-UP; LRS1-UP; K1Y1-UP)
988K (S/N: LWX1-UP; TWX1-UP)

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem



Illustration 1g06335724

In certain cases the 1R-0749 Fuel Filter can develop a small leak at the top plate. In most cases if these filters develop a leak the leak will be small and will show shortly after installation.

Solution

------ WARNING! ------

Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.


Inspect and replace with good 1R-0749 Fuel Filter.

Retain failed parts and check "Send It Back" for an open parts return request.

Caterpillar Information System:

308 Mini Hydraulic Excavators Maintenance Interval Schedule
New Software Is Now Used for Certain C175-16 Engines {7620} New Software Is Now Used for Certain C175-16 Engines {7620}
An Improved Engine Oil Lines on Certain G3500H HD Engines {1307, 1469} An Improved Engine Oil Lines on Certain G3500H HD Engines {1307, 1469}
G3500H 60Hz Generator Sets Flexible Coupling (Silicone Compression) - Inspect
G3500H 60Hz Generator Sets Flexible Coupling (Rubber) - Inspect
Rework Procedure for Generator Sets with the 262-8196 Generator Arrangement {4450} Rework Procedure for Generator Sets with the 262-8196 Generator Arrangement {4450}
C175 Tier 4 Final Engines for Caterpillar Built Machines Flywheel Housing - Remove
Installation Procedure of the Front and Left Side Camera on Certain 320 and 323 Next Generation Excavators {7348} Installation Procedure of the Front and Left Side Camera on Certain 320 and 323 Next Generation Excavators {7348}
120 and 120 AWD Motor Grader Circle Clearances - Check/Adjust
308 Mini Hydraulic Excavators Front Control System - If Equipped
320 D3 Hydraulic Excavators Engine Disassembly and Assembly Fuel Injection Nozzles - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Nitrogen Oxide Sensor - Calibrate
New Cylinder Pack Components are Now Used On Certain 3512 and 3516 Engines {1214, 1215} New Cylinder Pack Components are Now Used On Certain 3512 and 3516 Engines {1214, 1215}
794 AC Off-Highway Truck Field Assembly Films - Install
797F Tier 4 Off-Highway Truck Field Assembly Engine Aftertreatment System - Install
320 D3 Hydraulic Excavators Engine Disassembly and Assembly Engine Oil Filter Base - Remove and Install
797F Tier 4 Off-Highway Truck Engine Supplement Engine and Torque Converter - Remove and Install
301.5,301.6,301.7,301.8,302 Mini Hydraulic Excavator Machine Systems Front Idler and Track Adjuster - Remove
Installation of the 561-2355 Oil Cooler Lines Gp on Certain Next Generation Hydraulic Excavators {1378} Installation of the 561-2355 Oil Cooler Lines Gp on Certain Next Generation Hydraulic Excavators {1378}
Installation of the 558-1387 Front Lines Gp on Certain Next Generation Hydraulic Excavators {5057} Installation of the 558-1387 Front Lines Gp on Certain Next Generation Hydraulic Excavators {5057}
AC Compressor May Not Function Properly on Certain 320, 320 GC, and 323 Excavators {1802} AC Compressor May Not Function Properly on Certain 320, 320 GC, and 323 Excavators {1802}
320 D3 Hydraulic Excavators Engine Disassembly and Assembly Engine Oil Cooler - Remove and Install
A New Wastegate Shaft Part Number Released for G3600 Engines {1057} A New Wastegate Shaft Part Number Released for G3600 Engines {1057}
Certain G3500H Engines with CCV have Oil Carryover {1074} Certain G3500H Engines with CCV have Oil Carryover {1074}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.