New Aftercooler Heat Shield Assemblies is Now Used for Certain 3500 Marine Engines {1063, 1073}
- Engine
- 3512C (S/N: T3P1-308; TKP1-231; T3R1-302; T3S1-221; T3W1-258; T3Y1-200)
- 3516C (S/N: TKR1-227; TKS1-247; TKT1-243; TKX1-205; TKY1-353)
Description Of Change: The new heat shield assembly that is used helps prevent failure of the bellows assembly from rubbing.
Adaptable To: The following changes are adaptable to the products within the listed serial numbers, and are effective with all products after the listed serial numbers.
The new shield assembly allows for quicker installation and requires that all mounting hardware from the first 3 locations on the compressor tube shielding is removed. Table 1 contains the new part numbers for the shield assemblies.
Show/hide table
| New Part Number | Part Name | Qty |
|---|---|---|
| Shield As ((Large Frame Bellows)) | 1 | |
| Shield As ((Small Frame Bellows)) | 1 |
Caterpillar Information System:
Cat® PVT110, PVT115, PVT117, PVT120 Photo Voltaic Module {1471, 4822} Cat® PVT110, PVT115, PVT117, PVT120 Photo Voltaic Module {1471, 4822}
336, 336 GC and 340 Excavator Systems Cylinder Drift - Check - Empty Bucket
320 GC, 320 and 323 Excavator Production Measurement Application
C32 Marine Engines Auxiliary Water Pump - Remove
C9.3B Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
140 Motor Grader Transmission and Differential Oil Sample - Obtain
140 Motor Grader Transmission and Differential Oil Level - Check
140 Motor Grader Transmission and Differential Oil Filter and Screens - Replace/Clean
140 Motor Grader Transmission and Differential Oil - Change
140 Motor Grader Tandem Drive Oil Sample - Obtain
140 Motor Grader Tandem Drive Oil Level - Check
140 Motor Grader Tandem Drive Oil - Change
Rework Procedure of the Coolant Level Wiring Harness on Certain G3306B Generator Sets {1408, 4459, 7422, 7938} Rework Procedure of the Coolant Level Wiring Harness on Certain G3306B Generator Sets {1408, 4459, 7422, 7938}
140 Motor Grader Operator Controls
336 Excavators (Powered by C9.3 Tier 4 Engine) Engine Supplement Battery - Remove and Install
C9.3B Engines for Caterpillar Built Machines Temperature Sensor (Catalyst Inlet) - Remove and Install
140 Motor Grader Monitoring System
New Turbochargers and Cartridges Are Now Used for Certain 3500 Marine Engines {1052, 1056} New Turbochargers and Cartridges Are Now Used for Certain 3500 Marine Engines {1052, 1056}
320 GC, 320 and 323 Excavator Assist and E-Fence
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Power Train Hydraulic Tank
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Water Spray Lines
336, 336 GC and 340 Excavator Systems Cylinder Speed - Check
390F Excavator Machine Systems Position Sensor - Remove and Install - 374F and 390F Stick and Boom Rotary Position Sensor Remove and Install
CX38–P892 Petroleum Transmission Control Manifold - Disassemble