Tandem Drive Oil Level - Check
Show/hide table
| |
| Illustration 1 | g06250031 |
- Clean the surface area around the oil check plug.
- Loosen the oil check plug. If oil starts to come out, the oil level is sufficient.
- Maintain the oil level at or above the bottom of the opening for the oil check plug. If additional oil is necessary, perform the following Steps:
- Remove a plate from the walkway that is on top of the tandem drive housing. Removing the plate must be done to access one of the covers on the top of the tandem drive housing.
- Clean the area around one of the covers of any dirt or debris. Cleaning the area must be done before the cover is removed.
- Remove a cover from the top of the tandem drive housing. Fill the tandem drive housing with new oil. Refer to the following topics:
- Operation and Maintenance Manual, "Lubricant Viscosities"
- Operation and Maintenance Manual, "Capacities (Refill)"
- Clean the cover and install the cover on the top of the tandem drive housing.
- Install the plate to the walkway.
- Clean the oil check plug and install the oil check plug.
Caterpillar Information System:
140 Motor Grader Tandem Drive Oil - Change
140 Motor Grader Tandem Breather - Clean/Replace
Repair/Replacement Procedure for 5C-6108 Refueling Switch {1295} Repair/Replacement Procedure for 5C-6108 Refueling Switch {1295}
140 Motor Grader Steering Cylinder Ends and Tie Rods - Lubricate
140 Motor Grader Rollover Protective Structure (ROPS) - Inspect
140 Motor Grader Oil Filter (All Wheel Drive) - Replace - If Equipped
140 Motor Grader Moldboard Wear Strip - Inspect/Adjust/Replace
140 Motor Grader Hydraulic System Oil - Change
140 Motor Grader Fuses - Replace
C9.3B Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Inlet) - Remove and Install
140 Motor Grader Secondary Steering - Test
330, 330 GC, 336, 336 GC and 340 Excavator Tool Control Medium Pressure: Relief Valve (Main) - Test and Adjust
140 Motor Grader Tandem Drive Oil Sample - Obtain
140 Motor Grader Transmission and Differential Oil - Change
140 Motor Grader Transmission and Differential Oil Filter and Screens - Replace/Clean
140 Motor Grader Transmission and Differential Oil Level - Check
140 Motor Grader Transmission and Differential Oil Sample - Obtain
C9.3B Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
C32 Marine Engines Auxiliary Water Pump - Remove
320 GC, 320 and 323 Excavator Production Measurement Application
336, 336 GC and 340 Excavator Systems Cylinder Drift - Check - Empty Bucket
Cat® PVT110, PVT115, PVT117, PVT120 Photo Voltaic Module {1471, 4822} Cat® PVT110, PVT115, PVT117, PVT120 Photo Voltaic Module {1471, 4822}
New Aftercooler Heat Shield Assemblies is Now Used for Certain 3500 Marine Engines {1063, 1073} New Aftercooler Heat Shield Assemblies is Now Used for Certain 3500 Marine Engines {1063, 1073}
Rework Procedure of the Coolant Level Wiring Harness on Certain G3306B Generator Sets {1408, 4459, 7422, 7938} Rework Procedure of the Coolant Level Wiring Harness on Certain G3306B Generator Sets {1408, 4459, 7422, 7938}