Transmission and Differential Oil Level - Check
Show/hide table
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. |
Refer to Operation and Maintenance Manual, "Access Doors and Covers" for the location of the service points.
Show/hide table
Illustration 1 | g06250067 |
- Park the machine on a level surface.
- Open the front left access door.
- Clean the area around oil level gauge/fill cap (1).
- Start the engine and run the engine at low idle. Remove the oil level gauge/fill cap.
- With the oil at operating temperature, maintain the oil level between the marks on oil level gauge/fill cap (1). If necessary, add oil.
- Stop the engine.
- Close the access door.
Caterpillar Information System:
140 Motor Grader Transmission and Differential Oil Filter and Screens - Replace/Clean
140 Motor Grader Transmission and Differential Oil - Change
140 Motor Grader Tandem Drive Oil Sample - Obtain
140 Motor Grader Tandem Drive Oil Level - Check
140 Motor Grader Tandem Drive Oil - Change
140 Motor Grader Tandem Breather - Clean/Replace
Repair/Replacement Procedure for 5C-6108 Refueling Switch {1295} Repair/Replacement Procedure for 5C-6108 Refueling Switch {1295}
140 Motor Grader Steering Cylinder Ends and Tie Rods - Lubricate
140 Motor Grader Rollover Protective Structure (ROPS) - Inspect
140 Motor Grader Oil Filter (All Wheel Drive) - Replace - If Equipped
140 Motor Grader Moldboard Wear Strip - Inspect/Adjust/Replace
140 Motor Grader Hydraulic System Oil - Change
140 Motor Grader Transmission and Differential Oil Sample - Obtain
C9.3B Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
C32 Marine Engines Auxiliary Water Pump - Remove
320 GC, 320 and 323 Excavator Production Measurement Application
336, 336 GC and 340 Excavator Systems Cylinder Drift - Check - Empty Bucket
Cat® PVT110, PVT115, PVT117, PVT120 Photo Voltaic Module {1471, 4822} Cat® PVT110, PVT115, PVT117, PVT120 Photo Voltaic Module {1471, 4822}
New Aftercooler Heat Shield Assemblies is Now Used for Certain 3500 Marine Engines {1063, 1073} New Aftercooler Heat Shield Assemblies is Now Used for Certain 3500 Marine Engines {1063, 1073}
Rework Procedure of the Coolant Level Wiring Harness on Certain G3306B Generator Sets {1408, 4459, 7422, 7938} Rework Procedure of the Coolant Level Wiring Harness on Certain G3306B Generator Sets {1408, 4459, 7422, 7938}
140 Motor Grader Operator Controls
336 Excavators (Powered by C9.3 Tier 4 Engine) Engine Supplement Battery - Remove and Install
C9.3B Engines for Caterpillar Built Machines Temperature Sensor (Catalyst Inlet) - Remove and Install
140 Motor Grader Monitoring System