Rollover Protective Structure (ROPS) - Inspect
Show/hide table
NOTICE |
---|
Do not attempt to straighten the ROPS structure. Do not repair the ROPS by welding reinforcement plates to the structure. If there are any cracks in the welds, in the castings, or in any metal section of the ROPS, consult your Caterpillar dealer for repairs. |
Show/hide table
Illustration 1 | g06250009 |
There are four mounting bolts (1) for the ROPS. The mounting bolts are on each side of the cab.
- Inspect the ROPS for any loose bolts or any damaged bolts. Replace any damaged bolts or any missing bolts with only the original equipment parts.
- If necessary, tighten four mounting bolts (1). Refer to Specifications, SENR3130, "Torque Specifications" for the recommended torque.
- When you operate the machine on a rough surface, the ROPS may rattle or the ROPS may make a noise. If the ROPS rattles or if the ROPS makes a noise, replace the ROPS mounting supports.
Caterpillar Information System:
140 Motor Grader Oil Filter (All Wheel Drive) - Replace - If Equipped
140 Motor Grader Moldboard Wear Strip - Inspect/Adjust/Replace
140 Motor Grader Hydraulic System Oil - Change
140 Motor Grader Fuses - Replace
C9.3B Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Inlet) - Remove and Install
140 Motor Grader Secondary Steering - Test
330, 330 GC, 336, 336 GC and 340 Excavator Tool Control Medium Pressure: Relief Valve (Main) - Test and Adjust
320GC and 320 Excavator Engine Supplement Water Temperature Regulator - Remove and Install
140 Motor Grader Fuel System Water Separator - Drain
140 Motor Grader Fuel System Filter - Replace
140 Motor Grader Fuel System - Fill
330, 330 GC, 336, 336 GC and 340 Excavator Tool Control Medium Pressure: Relief Valve (Line) - Test and Adjust
140 Motor Grader Steering Cylinder Ends and Tie Rods - Lubricate
Repair/Replacement Procedure for 5C-6108 Refueling Switch {1295} Repair/Replacement Procedure for 5C-6108 Refueling Switch {1295}
140 Motor Grader Tandem Breather - Clean/Replace
140 Motor Grader Tandem Drive Oil - Change
140 Motor Grader Tandem Drive Oil Level - Check
140 Motor Grader Tandem Drive Oil Sample - Obtain
140 Motor Grader Transmission and Differential Oil - Change
140 Motor Grader Transmission and Differential Oil Filter and Screens - Replace/Clean
140 Motor Grader Transmission and Differential Oil Level - Check
140 Motor Grader Transmission and Differential Oil Sample - Obtain
C9.3B Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
C32 Marine Engines Auxiliary Water Pump - Remove