Required Tooling | |||
Tool | Part Number | Part Description | Qty |
A | 207-1601 | Rubber Lubricant | - |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Personal injury or death may result from failure to adhere to the following procedures. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
- Install connector (13) and fuel transfer pump relief valve (12). Tighten fuel transfer pump relief valve to a torque of
36 ± 3 N·m (27 ± 2 lb ft) .Show/hide tableIllustration 2 g06095734 - Lubricate the O-ring seal with Tooling (A). Install the O-ring seal, fuel transfer pump (11), bracket (8), bolts (10) (not shown), and bolts (9).
Show/hide table
Illustration 3 g06095545 - Install bracket (7) and bolts (6).
Show/hide table
Illustration 4 g06095533 - Install elbow assembly (5), elbow assembly (3).
- Connect hose assembly (4) and harness assembly (2).
Show/hide table
Illustration 5 g06095521 - Connect hose assembly (1).
Illustration 1 | g06095744 |