Conveyor Pulley (Head, First Stage) - Remove and Install
Start By:
- Remove first stage conveyor gerotor motor
- Remove first stage conveyor belt.
- Remove cotter pin (3), clevis pin (1) , and two washers (2). Repeat process for opposite end of tensioning cylinder (4). Remove tensioning cylinder (4).
- Repeat Step 1 for the opposite side of first stage conveyor.
Show/hide table
Illustration 2 g06096123 - Use a suitable lifting device to support the weight of first stage conveyor head pulley (5). The weight of first stage conveyor head pulley (5) is approximately
80 kg (176 lb) - Loosen bearing set screw (7). Remove four bolts (8). Remove plate assembly (6).
Show/hide table
Illustration 3 g06096134 - Remove first stage conveyor head pulley (5)
Show/hide table
| |
| Illustration 1 | g06095876 |
- Install first stage conveyor head pulley (5) in the reverse order of removal.
Caterpillar Information System:
C175-16 and C175-20 Locomotive Engines Fuel Control Valve - Remove and Install
SPF343 and SPF343C Trailer Mounted Pumpers Model View Illustrations
C175-16 and C175-20 Locomotive Engines Fuel Transfer Pump - Install
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Cylinder Is Noisy
C175-16 and C175-20 Locomotive Engines Fuel and Auxiliary Water Pump Drive - Remove and Install
A New Cylinder Liner Insert Is Now Used On Certain 3500 Engines {1201, 1217} A New Cylinder Liner Insert Is Now Used On Certain 3500 Engines {1201, 1217}
C175-16 and C175-20 Locomotive Engines Fuel Transfer Pump - Remove
TR35 Locomotive Transmission Transmission Oil Pump - Assemble
TR35 Locomotive Transmission Transmission Oil Pump - Disassemble
C175-16 and C175-20 Locomotive Engines Auxiliary Water Pump - Assemble
C175-16 and C175-20 Locomotive Engines Engine Oil Pan - Install
C175-16 and C175-20 Locomotive Engines Auxiliary Water Pump - Disassemble
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Camshaft
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Crankshaft
New Wide Band 02 Sensors and Software Are Now Used on Certain G3306B Turbocharger Engines {108H, 1408, 1920} New Wide Band 02 Sensors and Software Are Now Used on Certain G3306B Turbocharger Engines {108H, 1408, 1920}
C175-16 and C175-20 Locomotive Engines Fuel Lines - Install - High Pressure
C280 Marine Engines Solenoid Valve (DEF Return)
C175-16 Locomotive Engine Thermostatic Valve - Inspect
PM820, PM822, and PM825 Cold Planer Machine Systems Upper Sheave (Rotor Drive) - Remove and Install
C175-20 Locomotive Engine Aftercooler Core - Inspect/Clean
3500 Engines Gear Group (Rear)
C280 Marine Engines Diesel Exhaust Fluid Tank
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor Pivot - Remove and Install
C280 Marine Engines Air Pressure Regulator Group