Fuel Pressure Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the fuel shutoff valve to the OFF position.
Show/hide table
Illustration 1 g03859721 - Disconnect harness assembly (1) and harness assembly (2).
- Remove filtered fuel pressure sensor (3), unfiltered fuel pressure sensor (4), elbow (5), and elbow (6).
- Install filtered fuel pressure sensor (3) and unfiltered fuel pressure sensor (4) in the reverse order of removal.
- Lubricate that bore of filtered fuel pressure sensor (3) and unfiltered fuel pressure sensor (4) with the lubricant that is being sealed.
- Tighten filtered fuel pressure sensor (3) and unfiltered fuel pressure sensor (4) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
Caterpillar Information System:
C3.4B Engines Component Location
C3.4B Engines General Information
349F and 352F Excavators Machine System Specifications Front Lines
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump and Primary Fuel Filter
3512C Generator Set Engine Engine Speed Sensor - Remove and Install
XQ400 Power Module Model View Illustrations
C8.7 Marine Engine Crankshaft Gear - Remove and Install
3512C Generator Set Engine Atmospheric Pressure Sensor - Remove and Install
3512C Generator Set Engine Crankcase Pressure Sensor - Remove and Install
XQ400 Power Module Safety Messages
2015/09/04 A New Breather Hose Is Now Used on Certain 3512 Engines {1317}
C8.7 Marine Engine Crankshaft Pulley - Remove and Install
C280-08 Tier 4 Engine Turbocharger - Assemble
Software Updates for Certain Tier 4 Final Industrial Engines{1000, 1920} Software Updates for Certain Tier 4 Final Industrial Engines{1000, 1920}
Installation Procedure for the 467-8080 TLV2 Seat Suspension Harness Kit{1408, 7312, 7324} Installation Procedure for the 467-8080 TLV2 Seat Suspension Harness Kit{1408, 7312, 7324}
2015/07/23 Improved Lines Group for the Seat Suspension Is Now Available for Certain Machines {7312, 7324}
3512C Generator Set Engine Air Inlet Manifold - Remove and Install
794 AC Off-Highway Truck Field Assembly Brakes - Install
3512C Generator Set Engine Rocker Shaft and Pushrod - Install
G3606 and G3608 Engines Gear Group (Rear) - Remove and Install
XQ400 Power Module Coolant Level - Check
XQ400 Power Module Fan Drive Bearing - Lubricate
XQ400 Power Module Plate Locations and Film Locations
XQ400 Power Module Sensors and Electrical Components