Coolant Level - Check
Check the coolant level when the engine is stopped and cool.
Show/hide table
| |
| Illustration 1 | g03863248 |
Show/hide table
| |
| Illustration 2 | g00285520 |
|
Cooling system filler cap | |
Show/hide table
 |
|
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. |
- Remove the cooling system filler cap slowly in order to relieve pressure.
- Maintain the coolant level within
13 mm (0.5 inch) of the bottom of the filler pipe. If the engine is equipped with a sight glass, maintain the coolant level to the proper level in the sight glass.Show/hide table
Illustration 3 g00103639 Typical filler cap gaskets - Clean the cooling system filler cap and check the condition of the filler cap gaskets. Replace the cooling system filler cap if the filler cap gaskets are damaged. Reinstall the cooling system filler cap.
- Inspect the cooling system for leaks.
Caterpillar Information System:
G3606 and G3608 Engines Gear Group (Rear) - Remove and Install
3512C Generator Set Engine Rocker Shaft and Pushrod - Install
794 AC Off-Highway Truck Field Assembly Brakes - Install
3512C Generator Set Engine Air Inlet Manifold - Remove and Install
2015/07/23 Improved Lines Group for the Seat Suspension Is Now Available for Certain Machines {7312, 7324}
Installation Procedure for the 467-8080 TLV2 Seat Suspension Harness Kit{1408, 7312, 7324} Installation Procedure for the 467-8080 TLV2 Seat Suspension Harness Kit{1408, 7312, 7324}
Software Updates for Certain Tier 4 Final Industrial Engines{1000, 1920} Software Updates for Certain Tier 4 Final Industrial Engines{1000, 1920}
C280-08 Tier 4 Engine Turbocharger - Assemble
3512C Generator Set Engine Fuel Pressure Sensor - Remove and Install
C3.4B Engines Component Location
C3.4B Engines General Information
349F and 352F Excavators Machine System Specifications Front Lines
XQ400 Power Module Fan Drive Bearing - Lubricate
XQ400 Power Module Plate Locations and Film Locations
XQ400 Power Module Sensors and Electrical Components
Energy Storage System Rectifier Configuration
C280 Marine Engines Air Inlet and Exhaust System Operation - Aftertreatment
HPU300 Hydraulic Power Pack Transport Information
New Engine Monitoring System III Software Is Now Used on Certain 3508B, 3512B, 3512C, and 3516B Engines {7490, 7620} New Engine Monitoring System III Software Is Now Used on Certain 3508B, 3512B, 3512C, and 3516B Engines {7490, 7620}
349F and 352F Excavators Machine System Specifications Coupler Lines
349F and 352F Excavators Machine System Specifications Boom Lines
349F and 352F Excavators Machine System Specifications Coupler Lines
349F and 352F Excavators Machine System Specifications Auxiliary Hydraulic Lines
349F and 352F Excavators Machine System Specifications Drain Line