Water Temperature Regulator - Remove and Install
Start By:
- Remove the water lines (if applicable).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g03833806 - Remove nut (2), bolt (3), and bracket (4).
- Remove bolt (1), stud (6), and elbow (5).
Show/hide table
Illustration 2 g03833920 - Remove water temperature regulator (7).
- Install water temperature regulator (7) in the reverse order of removal.
Caterpillar Information System:
C9.3 Marine Engine Water Pump - Assemble
C9.3 Marine Engine Water Pump - Disassemble
C2.2 Engines For Caterpillar Built Machines Sensor Signal (Analog, Active) - Test
Installation Procedure for Excitation Modules 10 and 15{4467} Installation Procedure for Excitation Modules 10 and 15{4467}
C9.3 Marine Engine Water Pump - Remove and Install
3516C Industrial Engine Maintenance Interval Schedule
C9.3 Marine Engine Engine Oil Pump - Remove and Install
3516C Marine Engines Diesel Exhaust Fluid Pump - Remove and Install
3516C Marine Engines Electronic Control (Diesel Exhaust Fluid) - Remove and Install
C9.3 Marine Engine Engine Oil Cooler - Remove and Install - Combined Circuit Keel Cooling
3516C Marine Engines Pressure Sensor (Exhaust Inlet) - Remove and Install
3516C Marine Engines Temperature Sensor (Exhaust Inlet) - Remove and Install
C8.7 Marine Engines Expansion Tank
G3606 and G3608 Engines Aftercooler - Remove and Install
XQ400 Power Module Maintenance Interval Schedule
C9.3 Marine Engine Flywheel - Remove and Install
PM820, PM822, and PM825 Cold Planer Shipping the Machine
797F Off-Highway Truck Field Assembly Walkway (Left Hand) - Install
C9.3 Marine Engine Flywheel Housing - Remove and Install
C9.3 Marine Engine Vibration Damper and Pulley - Remove and Install
2015/05/15 A New Gas Tube Assembly Is Used on Certain 3512C Dynamic Gas Blending Oil Well Service Engines {1250}
Thinner Spacer Plates Not Recommended On Certain 3406E Through C18 On-Highway Truck Engines To Resolve Cylinder Liner Projection{1239} Thinner Spacer Plates Not Recommended On Certain 3406E Through C18 On-Highway Truck Engines To Resolve Cylinder Liner Projection{1239}
3512C and 3516C Industrial Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Procedure to Adjust Track Tension on Variable Gauge Undercarriages {4157, 4158} Procedure to Adjust Track Tension on Variable Gauge Undercarriages {4157, 4158}