Engine Oil Pump - Remove and Install
Start By:
- Remove oil pan.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1), bolts (5), pickup tube (2), and the gasket.
- Remove bolt (4), bolt (6), tube assembly (3), and the O-ring seals.
- Remove bolts (9) and engine oil pump (7).
Show/hide table
Illustration 1 | g03833385 |
- Install engine oil pump (7) in the reverse order of removal.
Caterpillar Information System:
3516C Marine Engines Diesel Exhaust Fluid Pump - Remove and Install
3516C Marine Engines Electronic Control (Diesel Exhaust Fluid) - Remove and Install
C9.3 Marine Engine Engine Oil Cooler - Remove and Install - Combined Circuit Keel Cooling
3516C Marine Engines Pressure Sensor (Exhaust Inlet) - Remove and Install
3516C Marine Engines Temperature Sensor (Exhaust Inlet) - Remove and Install
3516C Marine Engines Temperature Sensor (Exhaust Outlet) - Remove and Install
2015/05/12 New Troubleshooting Procedure Is Now Available for all Cat® Products Equipped with PL321 VIMS (PL321 VSR) {7606}
C9.3 Marine Engine Engine Oil Cooler - Remove and Install
Cat® Command For Hauling MID 039 - CID 0841 - FMI 03
Cat® Command For Hauling MID 039 - CID 0840 - FMI 03
Cat® Command For Hauling MID 039 - CID 0839 - FMI 03
C9.3 Marine Engine Engine Oil Filter Base - Remove and Install - Left-Hand Simplex
3516C Industrial Engine Maintenance Interval Schedule
C9.3 Marine Engine Water Pump - Remove and Install
Installation Procedure for Excitation Modules 10 and 15{4467} Installation Procedure for Excitation Modules 10 and 15{4467}
C2.2 Engines For Caterpillar Built Machines Sensor Signal (Analog, Active) - Test
C9.3 Marine Engine Water Pump - Disassemble
C9.3 Marine Engine Water Pump - Assemble
C9.3 Marine Engine Water Temperature Regulator - Remove and Install
C8.7 Marine Engines Expansion Tank
G3606 and G3608 Engines Aftercooler - Remove and Install
XQ400 Power Module Maintenance Interval Schedule
C9.3 Marine Engine Flywheel - Remove and Install
PM820, PM822, and PM825 Cold Planer Shipping the Machine