Water Pump - Assemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-0510 | Driver Gp | 1 |
B | 5P-9722 | Seal Driver | 1 |
C | 207-1601 | Rubber Lubricant | - |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) and a suitable press to install hub (12) on shaft assembly (6).
- Use Tooling (A) and a suitable press to install shaft assembly (6) into housing (5). Install shaft assembly (6) until the bearing is flush with housing (5).
- Use Tooling (B) and a suitable press to install seal assembly (11) in housing (5). The operating height of seal assembly (11) is
10.92 ± 0.13 cm (4.300 ± 0.050 inch) . - Use Tooling (A) and a suitable press to install impeller (10) onto shaft assembly (6).
- Apply Tooling (C) to O-ring seal (9). Install seal (4), seal (3), and O-ring seal (9).
- Install cover (2), bolts (8), and O-ring seal (1).
- Install pulley (13) and bolts (7).
Show/hide table
Illustration 1 | g03833684 |
Caterpillar Information System:
C9.3 Marine Engine Water Pump - Disassemble
C2.2 Engines For Caterpillar Built Machines Sensor Signal (Analog, Active) - Test
Installation Procedure for Excitation Modules 10 and 15{4467} Installation Procedure for Excitation Modules 10 and 15{4467}
C9.3 Marine Engine Water Pump - Remove and Install
3516C Industrial Engine Maintenance Interval Schedule
C9.3 Marine Engine Engine Oil Pump - Remove and Install
3516C Marine Engines Diesel Exhaust Fluid Pump - Remove and Install
3516C Marine Engines Electronic Control (Diesel Exhaust Fluid) - Remove and Install
C9.3 Marine Engine Engine Oil Cooler - Remove and Install - Combined Circuit Keel Cooling
3516C Marine Engines Pressure Sensor (Exhaust Inlet) - Remove and Install
3516C Marine Engines Temperature Sensor (Exhaust Inlet) - Remove and Install
3516C Marine Engines Temperature Sensor (Exhaust Outlet) - Remove and Install
C9.3 Marine Engine Water Temperature Regulator - Remove and Install
C8.7 Marine Engines Expansion Tank
G3606 and G3608 Engines Aftercooler - Remove and Install
XQ400 Power Module Maintenance Interval Schedule
C9.3 Marine Engine Flywheel - Remove and Install
PM820, PM822, and PM825 Cold Planer Shipping the Machine
797F Off-Highway Truck Field Assembly Walkway (Left Hand) - Install
C9.3 Marine Engine Flywheel Housing - Remove and Install
C9.3 Marine Engine Vibration Damper and Pulley - Remove and Install
2015/05/15 A New Gas Tube Assembly Is Used on Certain 3512C Dynamic Gas Blending Oil Well Service Engines {1250}
Thinner Spacer Plates Not Recommended On Certain 3406E Through C18 On-Highway Truck Engines To Resolve Cylinder Liner Projection{1239} Thinner Spacer Plates Not Recommended On Certain 3406E Through C18 On-Highway Truck Engines To Resolve Cylinder Liner Projection{1239}
3512C and 3516C Industrial Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves