Gas Shutoff Valve - Remove and Install - Dynamic Gas Blending
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn OFF the gas supply.
- Remove bolts (1), bolts (2), and gas shutoff valve (3).
Show/hide table
| |
| Illustration 1 | g03414218 |
- Install gas shutoff valve (3) in the reverse order of removal.
Caterpillar Information System:
C7.1 Industrial Engine Fan Clearance - Check
C13 Generator Set Engine Turbocharger - Remove and Install
C13 Generator Set Engine Vibration Damper and Pulley - Remove and Install
3512E Petroleum Engines Fuel Priming Pump - Remove and Install
349F and 352F Excavator Machine System Connector Locations
C13 Generator Set Engine Electric Starting Motor - Remove and Install
C13 Generator Set Engine Electronic Control Module - Remove and Install
2013/09/09 A New Elbow Is Used on Certain 3500 Engines {1371}
330F MHPU Mobile Hydraulic Power Unit Machine System Solenoid Valve (Proportional Reducing) - Calibrate - Boom Down Regeneration
3516C Locomotive Engines Selective Catalytic Reduction Relay - Test
C13 Generator Set Engine Alternator - Remove and Install
C7.1 Engines Diesel Particulate Filter Temperature Is Low
3512C Petroleum Engines Air Shutoff - Remove and Install
C13 Generator Set Engine Engine Support (Front) - Remove and Install
C7.1 Industrial Engine Fault Logging
3512C Petroleum Engines Engine Oil Cooler - Remove and Install
C7.1 Engines DEF Pressure Is High
3512E Petroleum Engines Engine Oil Cooler - Disassemble
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies DC Bus Capacitor - Remove and Install
3512E Petroleum Engines Engine Oil Cooler - Assemble
3512E Petroleum Engines Engine Oil Pump - Remove and Install
3512C Petroleum Engines Vibration Damper - Remove and Install
3512E Petroleum Engines Flywheel Housing - Remove
3512C Petroleum Engines Catalyst - Remove and Install