Crankshaft Rear Seal and Wear Sleeve - Remove and Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 1U-7600 | 滑锤拉拔器 | 1 |
B | 6V-3143
或 1U-7325 |
扭转接头 | 1 |
C | 5P-7409 | 套筒扭转器 | 1 |
开始:
- 拆下飞轮。 参考拆解和组装, "飞轮 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
Show/hide table
注意 |
---|
每次从耐磨衬套上拆下曲轴密封件时,都必须安装上新的耐磨衬套和曲轴密封件。 |
- 在曲轴后密封 (1) 上钻出三个等距的孔。 使用工具 (A) 拆下曲轴后密封 (1)。
Show/hide table
图 2 g00659240 - 在后壳体和耐磨衬套 (2) 之间插入工具 (B)。
Show/hide table
注意 对套筒变扭器用力过大可能会导致变扭器接头损坏壳体,使之破裂。 为避免损坏发动机,拆卸耐磨衬套时用力不要过大。
- 在工具 (B) 和耐磨衬套 (2) 之间插入工具 (C)。 小心地转动工具 (C) 直到工具边缘使耐磨衬套 (2) 产生了折痕。
在耐磨衬套 (2) 周围重复该步骤,直到可手动拆下耐磨衬套 (2)。
Show/hide table
图 1 | g00659239 |
- 按照与拆卸相反的顺序安装曲轴后油封 (1) 和耐磨衬套 (2)。
Caterpillar Information System:
G3512H and G3516H Generator Set Engines Crankshaft Front Seal and Wear Sleeve - Remove and Install
C280-16 Generator Set Engine for Nuclear Applications Speed Control
G3512H and G3516H Generator Set Engines Rocker Shaft and Push Rod - Remove and Install
C280-16 Generator Set Engine for Nuclear Applications Engine Speed/Timing Sensor
C280-16 Generator Set Engine for Nuclear Applications Camshaft Timing
G3500 Engines Piston and Rings
C175-16 Engine for 795F Series AC Off-Highway Trucks Auxiliary Water Pump
C280 Marine Engines Lubrication System Operation
G3500 Engines Turbocharger
C13, C15, and C18 Tier 4 Final Engines Electronic Control (Diesel Exhaust Fluid)
G3500 A3 Engines Exhaust Manifold - Water Cooled
C175-16 Locomotive Engine Pressure Control Valve - Oil Regulator Valve and Oil Bypass Valve
G3512H and G3516H Generator Set Engines Flywheel Housing - Remove and Install
G3512H and G3516H Generator Set Engines Gear Group (Rear) - Remove and Install
C280 Marine Engines Engine Governing - Adjust
G3512H and G3516H Generator Set Engines Crankshaft Main Bearings - Remove and Install
C4.4 and C7.1 Engines Injector Solenoid - Test
C13, C15, and C18 Tier 4 Final Engines Manifold (Diesel Exhaust Fluid)
C9.3 Tier 4 Final Engines Cylinder Block Cover Group
3500 Engines Camshaft
G3512H and G3516H Generator Set Engines Pistons and Connecting Rods - Remove and Install
3516B and 3516C Engines For MT4400D AC Off-Highway Trucks Electronic Service Tools
2013/11/25 A New Heavy-Duty Aftercooler is Available for Certain C32 Commercial Marine Engines Operating in Seawater {1063}
G3512H and G3516H Generator Set Engines Cylinder Liner - Remove and Install