C9.3 Engine for Caterpillar Built Machines Caterpillar


Water Pump

Usage:

725C2 2L6



图 1g02146654

(2) 轴组件

(1) 四个螺栓的扭矩 ... 55 ± 10 N·m (41 ± 7 lb ft)

(3) 冲洗轴承和水泵壳体组件。

(B) 泵叶轮和泵壳间的间隙 ... 0.75 ± 0.25 mm (0.030 ± 0.010 in)

(C) 水泵密封组件的工作高度 ... 10.92 ± 0.13 mm (0.430 ± 0.005 in)

(D) 皮带轮前表面到泵壳体表面的距离 ... 132.9 ± 0.3 mm (5.23 ± 0.01 in)




图 2g02531937

(4) 螺栓扭矩 ... 30 ± 7 N·m (266 ± 62 lb in)

注: 关于轴组件和水泵密封组件的完整安装程序,请参阅拆解和组装。

Caterpillar Information System:

Cat® Alarm and Protection System Control Panel Overview (RP 410)
C9 Industrial Engines Aftercooler Core - Inspect/Clean/Test
C9 Industrial Engines Configuration Parameters
DPF Temperature Sensor Thread Salvage Procedure for Certain C7 thru C15 On-Highway Engines{108F, 1439, 1919, 7400} DPF Temperature Sensor Thread Salvage Procedure for Certain C7 thru C15 On-Highway Engines{108F, 1439, 1919, 7400}
2012/01/16 Special Instruction, REHS7131 , "Procedure for the Installation of the 372-1187 Nitrogen Oxide Sensor Gp and the 379-0138 Sensor Kit (NITROGEN OXIDE)" Is Available {1408, 1439, 191N, 7400}
2011/07/18 New Pressure Switch Is Now Used For Air Conditioner Refrigerant On Certain Cat Products {1435, 1809}
2011/05/12 New Software Is Now Released for Product Link PL522/523 Systems On All Cat Product {7606}
C3.4B Engines for Caterpillar Built Machines Piston Height - Inspect
C3.4B Engines for Caterpillar Built Machines Fuel System - Prime
C3.4B Engines for Caterpillar Built Machines V-Belt - Test
C3.4B Engines for Caterpillar Built Machines Flywheel Housing - Inspect
C3.4B Engines for Caterpillar Built Machines Flywheel - Inspect
3500B and 3500C Marine Engines Camshaft
C15 Petroleum Engines Turbocharger
Procedure for the Installation of the 372-1187 Nitrogen Oxide Sensor Gp and the 379-0138 Sensor Kit (NITROGEN OXIDE){191N} Procedure for the Installation of the 372-1187 Nitrogen Oxide Sensor Gp and the 379-0138 Sensor Kit (NITROGEN OXIDE){191N}
797F and 797F XQ Off-Highway Truck Braking System Control Valve (Brake) - If Equipped
3500 Engines Camshaft
C13, C15, and C18 Tier 4 Final Engines Cylinder Block
3406C Industrial Engine Air Compressor - Check
UPSB220 Uninterruptible Power Supply Basic Preventive Maintenance
C9 Industrial Engines Belts - Inspect/Adjust/Replace
UPSB220 Uninterruptible Power Supply Unit Initial Check
UPSB220 Uninterruptible Power Supply Metering - Check
UPSB220 Uninterruptible Power Supply System Shutdown
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.