Before Starting Engine
在发动机起动之前，进行所需的日常保养和其它的定期保养内容。 检查发动机室。 此项检查可以帮助防止日后大的修理。 有关详细信息，请参考操作和保养手册, "保养周期表"。
- 确保发动机有充足的燃油供给。
- 打开供油阀（如有配备）。
如果发动机数周未起动，燃油可能从燃油系统中泄掉。 空气可能进入滤清器壳体。 并且更换燃油滤清器时，一些气泡将被困在发动机燃油系统中。 在这些情况下，应该充注燃油系统。 更多有关泵注燃油系统的信息资料，请参考操作和保养手册, "燃油系统 - 泵注"。 此外，检查燃油技术规格是否正确，以及燃油状况是否正常。 请参阅操作和保养手册, "燃油建议"。
Show/hide table
 |
|
发动机排气含有对人体有害的燃烧产物。 必须在良好通风的场所起动和运转发动机，如果在封闭场所，要将废气排到外面去。 |
- 如果起动开关或操纵装置上系有一个"不准操作"警告标签或类似警告标签，切勿起动发动机或移动任何操控装置。
- 复位所有关断装置或报警部件。
- 确保已脱开任何被驱动设备。 最大限度降低电气负载并卸掉任何电气负载。
Caterpillar Information System:
C1.5 and C2.2 Industrial Engines Configuration Parameters
C1.5 and C2.2 Industrial Engines Engine Operation with Intermittent Diagnostic Codes
C1.5 and C2.2 Industrial Engines Engine Operation with Active Diagnostic Codes
C1.5 and C2.2 Industrial Engines Fault Logging
C1.5 and C2.2 Industrial Engines Diagnostic Lamp
G3406 and G3412 Generator Sets Varistor - Inspect
G3500 Generator Sets Stator Winding Temperature - Test
G3516 Power Module Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
3500 Generator Sets Space Heater - Test
G3406 Engine Inlet Air System - Check
3512C HD SR500 Generator Sets Generator Winding Insulation - Test
C27 and C32 Generator Sets Generator Winding - Test
C1.5 and C2.2 Industrial Engines Starting the Engine
C1.5 and C2.2 Industrial Engines Engine Operation
320E and 323E Excavators Hydraulic System Swing Drive
2010/09/27 New Parts Are Used for the Number One Planetary Carrier on CX31 On-Highway Transmissions {3160}
C1.5 and C2.2 Industrial Engines Welding on Engines with Electronic Controls
C1.5 and C2.2 Industrial Engines System Pressure Release
320E and 323E Excavators Fuel Tank Shutoff and Drain Control
3500 and 3500B Engines Safety Messages
2010/10/13 Improved Software Is Used for C280 Marine Propulsion Engines {1901, 1920}
Repair of Web Cracks In Final Drive Planetary Carriers {4092} Repair of Web Cracks In Final Drive Planetary Carriers {4092}
C6.6 Industrial Engine Pressure Sensor (DPF) - Remove and Install - Clean Emissions Module
Procedure for Ordering Vintage Parts {0374, 1000, 7000} Procedure for Ordering Vintage Parts {0374, 1000, 7000}