Configuration Parameters
系统配置参数影响发动机的排放或发动机的功率。 配置参数在工厂进行编程设定。 通常情况下，在发动机的整个寿命期间，请勿更改系统配置参数。 如果更换电子控制模块（ECM）的话，则必须重新编程设定系统配置参数。 如果更换了 ECM 软件，则不需要重新编程设置系统配置参数。
有关更多信息，请参阅故障诊断与排除, "系统配置参数"。
Caterpillar Information System:
C1.5 and C2.2 Industrial Engines Engine Operation with Intermittent Diagnostic Codes
C1.5 and C2.2 Industrial Engines Engine Operation with Active Diagnostic Codes
C1.5 and C2.2 Industrial Engines Fault Logging
C1.5 and C2.2 Industrial Engines Diagnostic Lamp
G3406 and G3412 Generator Sets Varistor - Inspect
G3500 Generator Sets Stator Winding Temperature - Test
G3516 Power Module Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
3500 Generator Sets Space Heater - Test
G3406 Engine Inlet Air System - Check
3512C HD SR500 Generator Sets Generator Winding Insulation - Test
C27 and C32 Generator Sets Generator Winding - Test
PMG3516 Power Module Fuel Filter Differential Pressure - Check
C1.5 and C2.2 Industrial Engines Before Starting Engine
C1.5 and C2.2 Industrial Engines Starting the Engine
C1.5 and C2.2 Industrial Engines Engine Operation
320E and 323E Excavators Hydraulic System Swing Drive
2010/09/27 New Parts Are Used for the Number One Planetary Carrier on CX31 On-Highway Transmissions {3160}
C1.5 and C2.2 Industrial Engines Welding on Engines with Electronic Controls
C1.5 and C2.2 Industrial Engines System Pressure Release
320E and 323E Excavators Fuel Tank Shutoff and Drain Control
3500 and 3500B Engines Safety Messages
2010/10/13 Improved Software Is Used for C280 Marine Propulsion Engines {1901, 1920}
Repair of Web Cracks In Final Drive Planetary Carriers {4092} Repair of Web Cracks In Final Drive Planetary Carriers {4092}
C6.6 Industrial Engine Pressure Sensor (DPF) - Remove and Install - Clean Emissions Module