G3406 and G3412 Generator Sets Caterpillar


Varistor - Inspect

Usage:

PMG3516 GJK


Ilustrasi 1g00677004
Diagram Pengawatan Generator PMPE
(CR1-CR6) Dioda
(CR7) Varistor
(L1) Medan exciter (stator)
(L2) Armatur exciter (rotor)
(L3) Medan utama (rotor)
(L4) Armatur utama (stator)
(L5) Armatur exciter pilot
(PM) Magnet permanen
(RFA) Rakitan medan berputar
(CST) Transformer yang disuplai pelanggan

Ohmmeter

Ohmmeter dapat digunakan untuk memeriksa varistor (CR7). Letakkan ohmmeter menghadap varistor. Resistan harus minimum 15.000 ohm. Jika resistan kurang dari 15.000 ohm, varistor rusak.

Lampu Pengujian



Ilustrasi 2g00555113
Lampu Pengujian

Bacalah lampu pengujian yang ditampilkan dalam Ilustrasi 2. Ikuti langkah-langkah ini untuk menguji varistor:

  1. Lepaskan sambungan kabel varistor (CR7).

  2. Letakkan lampu uji menghadap varistor.

  3. Amati hasilnya. Lampu seharusnya tidak menyala.

  4. Balik lampu pengujian.

  5. Amati hasilnya. Lampu seharusnya tidak menyala.

Jika lampu pengujian menyala pada arah mana pun, ada hubung singkat pada varistor. Ganti varistor yang rusak dengan varistor dengan karakteristik kerja yang sebanding. Sertakan informasi berikut bila akan memesan varistor pengganti:

  • Nomor suku cadang varistor

  • Nomor seri generator

Setelah varistor diganti, pastikan bahwa ikatan kawat kumparan medan dililitkan dengan kencang ke poros. Juga, pastikan bahwa ikatan kawat kumparan medan terikat dengan kencang.

Caterpillar Information System:

G3500 Generator Sets Stator Winding Temperature - Test
G3516 Power Module Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
3500 Generator Sets Space Heater - Test
G3406 Engine Inlet Air System - Check
3512C HD SR500 Generator Sets Generator Winding Insulation - Test
C27 and C32 Generator Sets Generator Winding - Test
PMG3516 Power Module Fuel Filter Differential Pressure - Check
G3306B Generator Sets Exhaust Piping - Check
3512C HD Locomotive Engine Emissions Warranty Information
C7.1 (Mech) Industrial Engine Fuel Filter Base - Secondary Fuel Filter Base
C7.1 (Mech) Industrial Engine Fuel Filter Base - Primary Fuel Filter Base
3512C HD Locomotive Engine Starting Motor - Inspect - If equipped
C1.5 and C2.2 Industrial Engines Diagnostic Lamp
C1.5 and C2.2 Industrial Engines Fault Logging
C1.5 and C2.2 Industrial Engines Engine Operation with Active Diagnostic Codes
C1.5 and C2.2 Industrial Engines Engine Operation with Intermittent Diagnostic Codes
C1.5 and C2.2 Industrial Engines Configuration Parameters
C1.5 and C2.2 Industrial Engines Before Starting Engine
C1.5 and C2.2 Industrial Engines Starting the Engine
C1.5 and C2.2 Industrial Engines Engine Operation
320E and 323E Excavators Hydraulic System Swing Drive
2010/09/27 New Parts Are Used for the Number One Planetary Carrier on CX31 On-Highway Transmissions {3160}
C1.5 and C2.2 Industrial Engines Welding on Engines with Electronic Controls
C1.5 and C2.2 Industrial Engines System Pressure Release
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.