Fuel Filter Base - Remove and Install - Secondary
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 185-3630 | Strap Wrench As | 1 |
- Turn the fuel supply to the OFF position and turn the power disconnect switch to the OFF position.
Show/hide table
Illustration 1 g02080637 - Disconnect harness assemblies (1).
- Use Tooling (A) in order to remove fuel filters (5) from fuel filter base (3).
- Disconnect tube assemblies (2).
- Remove bolts (4) and remove fuel filter base (3).
- Install the fuel filters and the fuel filter base in the reverse order.
- Lubricate the seal that is found on the fuel filter with the fluid that is being sealed. Use Tooling (A) in order to tighten fuel filters (5) to a torque of
35 ± 3 N·m (26 ± 2 lb ft) .
- Lubricate the seal that is found on the fuel filter with the fluid that is being sealed. Use Tooling (A) in order to tighten fuel filters (5) to a torque of
Show/hide table
NOTICE |
---|
Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary. |
Caterpillar Information System:
CX31-P600 Petroleum Transmission Magnetic Screen (Transmission) - Clean - Dropbox
2012/03/09 New Boots for the Joystick Control in the Operator Station Are Now Available for Certain Excavators {5705}
C4.4 Industrial Engine Monitoring System - Table for the Indicator lamps
Inspection of the Duo-cone Seal Gp{4050, 4051, 7561} Inspection of the Duo-cone Seal Gp{4050, 4051, 7561}
C27 and C32 Tier 4 Engines Exhaust Manifold
797 Off-Highway Truck Platform (Powered Stairway) - Lubricate - If Equipped
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
797 Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil - Change - If Equipped
The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000} The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000}
C13, C15, and C18 Tier 4 Interim Engines Aftertreatment Cooling Fan - Test
C6.6 Marine Generator Set E539 High Intake Manifold Air Temperature
C6.6 Marine Generator Set E398 Low Fuel Rail Pressure
Procedure for the Proper Installation and Alignment of the Base Mounts on C18 Marine Generator Sets{1021, 7002} Procedure for the Proper Installation and Alignment of the Base Mounts on C18 Marine Generator Sets{1021, 7002}
2010/02/10 New Communication Software for the PL1000E Is Now Used on Commercial Engines {7620}
2010/02/03 A Long Term Storage and Recovery Procedure Is Now Available for Certain Commercial Engines {1000}
EMCP4.1/EMCP4.2 Component Location
C175-16 Locomotive Engine Fuel Control Manifold
3508C, 3512C and 3516C Locomotive Engines Turbocharger Oil Lines
3508C, 3512C and 3516C Locomotive Engines Water Lines
3508C, 3512C and 3516C Locomotive Engines Water Lines
C175-16 Locomotive Engine Fuel Lines
966H and 972H Wheel Loaders Leaving the Machine
2010/01/27 New Metering Pump Groups For Steering Control Prevent Oil Leaks {4300, 4301, 4312}
12M Series 2, 140M Series 2 and 160M Series 2 Motor Graders Machine Systems Air Lines