Monitoring System - Table for the Indicator lamps
注: 工作期间琥珀色警告灯有三种状态，常亮、闪烁和快速闪烁。 该排序对警告的重要性提供可见指示。 某些应用可能安装了可听警告。
确保发动机按照正确周期进行保养。 缺少保养可能导致警告灯点亮。 有关保养的正确周期，请参阅操作和保养手册, "保养周期表"。
Show/hide table
| 警告灯 | 停机灯 | 灯状态 | 指示描述 | 发动机状态 |
|---|---|---|---|---|
| 打开 | 打开 | 灯检查 | 钥匙开关移至打开位置时，灯点亮 2 秒然后熄灭。 | 钥匙开关接通但发动机未盘车。 |
| 熄灭 | 熄灭 | 没有故障 | 发动机操作时，没有激活的警告、诊断代码或事件代码。 | 发动机操作，未检测到故障。 |
| 持续发光 | 熄灭 | 警告 | 1 级警告 | 发动机操作正常，但发动机电子管理系统存在至少一个故障。 |
| 闪烁 | 熄灭 | 警告 | 2 级警告 | 继续操作发动机，但警告的重要级别增大。 取决于具体故障和严重性，发动机可能节流。 如果继续操作发动机，则可能对其造成损伤。 |
| 闪烁 | 打开 | 发动机停机 | 3 级警告 如果警告灯和停机灯都在工作，该问题表明存在下列情况之一。 1. 至少一个发动机保护策略停机值被超出。 2. 检测到严重的现行诊断代码。 一小段时间后，发动机可能停机。 |
发动机停机或即将停机。 至少一个发动机监控参数超出发动机停机极限值。 这种模式的指示灯可能是由于检测到严重的现行诊断代码引起。 |
Caterpillar Information System:
Inspection of the Duo-cone Seal Gp{4050, 4051, 7561} Inspection of the Duo-cone Seal Gp{4050, 4051, 7561}
C27 and C32 Tier 4 Engines Exhaust Manifold
797 Off-Highway Truck Platform (Powered Stairway) - Lubricate - If Equipped
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
797 Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil - Change - If Equipped
The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000} The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000}
C13, C15, and C18 Tier 4 Interim Engines Aftertreatment Cooling Fan - Test
C6.6 Marine Generator Set E539 High Intake Manifold Air Temperature
C6.6 Marine Generator Set E398 Low Fuel Rail Pressure
C6.6 Marine Generator Set E396 High Fuel Rail Pressure
C6.6 Marine Generator Set E362 Engine Overspeed
C13, C15, and C18 Tier 4 Interim Engines Data Link - Test
2012/03/09 New Boots for the Joystick Control in the Operator Station Are Now Available for Certain Excavators {5705}
CX31-P600 Petroleum Transmission Magnetic Screen (Transmission) - Clean - Dropbox
C15 and C18 Industrial Engines Fuel Filter Base - Remove and Install - Secondary
Procedure for the Proper Installation and Alignment of the Base Mounts on C18 Marine Generator Sets{1021, 7002} Procedure for the Proper Installation and Alignment of the Base Mounts on C18 Marine Generator Sets{1021, 7002}
2010/02/10 New Communication Software for the PL1000E Is Now Used on Commercial Engines {7620}
2010/02/03 A Long Term Storage and Recovery Procedure Is Now Available for Certain Commercial Engines {1000}
EMCP4.1/EMCP4.2 Component Location
C175-16 Locomotive Engine Fuel Control Manifold
3508C, 3512C and 3516C Locomotive Engines Turbocharger Oil Lines
3508C, 3512C and 3516C Locomotive Engines Water Lines
3508C, 3512C and 3516C Locomotive Engines Water Lines
C175-16 Locomotive Engine Fuel Lines