Alternator - Remove and Install
Show/hide table
Personal injury can result from failure to disconnect the battery. First, disconnect the negative battery cable. Then, disconnect the positive battery cable. A positive power lead can cause sparks if the battery is not disconnected. Sparks can possibly result in battery explosion or fire. |
- Disconnect the battery cables.
- Remove the belt. Refer to Operation and Maintenance Manual, "Belt - Inspect/Adjust/Replace".
Show/hide table
Illustration 1 g01871219 - Remove bolts (1) and alternator (2).
- Install alternator (2) in reverse order of removal.
- Tighten nut (3) to a torque of
127 ± 10 N·m (94 ± 8 lb ft) . - Tighten nut (4) to a torque of
18 ± 2 N·m (161 ± 21 lb in) . - Tighten bolt (5) to a torque of
5± 1 N·m (39 ± 9 lb in) .
Show/hide tableIllustration 2 g01872415 - Tighten nut (3) to a torque of
Caterpillar Information System:
C9.3 Engines for Caterpillar Built Machines Engine Top Speed Is Not Obtained
C13 Engines for Caterpillar Built Machines Flywheel - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Engine Stalls at Low RPM
C13 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Crankcase Pressure Is High
C13 Engine for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
Installation and Maintenance of the Microfilter for Natural Gas {1261} Installation and Maintenance of the Microfilter for Natural Gas {1261}
2009/04/06 A New Paint Scheme Is Used on C7 through C32 Marine Engines with the Pleasurecraft Finish {1000, 7559, 7581}
2009/04/13 Procedure to Install the Muffler Bracket on Weatherproof Generator Set Enclosures and Improved Sealing of the Enclosures {0649, 1062}
C13, C15, and C18 Tier 4 Interim Engines Engine Overspeeds
C13 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C9.3 Engines for Caterpillar Built Machines Symptom Troubleshooting
Quick Start Guide for Manual Paralleling{7451} Quick Start Guide for Manual Paralleling{7451}
C7.1 Industrial Engine Model View Illustrations
C13, C15, and C18 Tier 4 Interim Engines Exhaust Has Excessive White Smoke
C13 Engine for Caterpillar Built Machines Refrigerant Compressor - Remove and Install
2009/04/13 An Improved PL1000E Electronic Control Module Is Now Used {7610}
C13 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
2009/04/06 New Springs Are Now Used on CX31 On-Highway Transmission {3155}
C15 and C18 Engines for Caterpillar Built Machines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Solenoid Valve (Exhaust Balance) - Remove and Install
C13 Engines for Caterpillar Built Machines Front Cover - Remove and Install
795F AC and 795F AC XQ Off-Highway Trucks Ground Fault - Check
525D, 535D, 545D and 555D Wheel Skidders Symptom Troubleshooting