Crankshaft Front Seal - Remove and Install
Start By:
- Remove the vibration damper and the pulley.
- Remove nuts (1) and crankshaft front seal (2).
Show/hide table
Illustration 1 | g01870637 |
- Install crankshaft front seal (2) in reverse order of removal.
- Tighten nuts (1) in a numerical sequence.
Show/hide tableIllustration 2 g01870695
Note: Leave the shipping sleeve in place in order to install the crankshaft front seal. The crankshaft front seal must be installed dry.
Caterpillar Information System:
C13, C15, and C18 Tier 4 Interim Engines Crankcase Pressure Is High
C13 Engine for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
Installation and Maintenance of the Microfilter for Natural Gas {1261} Installation and Maintenance of the Microfilter for Natural Gas {1261}
2009/04/06 A New Paint Scheme Is Used on C7 through C32 Marine Engines with the Pleasurecraft Finish {1000, 7559, 7581}
2009/04/13 Procedure to Install the Muffler Bracket on Weatherproof Generator Set Enclosures and Improved Sealing of the Enclosures {0649, 1062}
C13, C15, and C18 Tier 4 Interim Engines Engine Overspeeds
C13 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C9.3 Engines for Caterpillar Built Machines Symptom Troubleshooting
C7.1 Industrial Engine and Generator Set ECM Memory - Test
C15 and C18 Engines for Caterpillar Built Machines Belt Tensioner - Remove and Install
C12 Marine Engines Engine and Marine Transmission Operation
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0271 - FMI 03
C13, C15, and C18 Tier 4 Interim Engines Engine Stalls at Low RPM
C13 Engines for Caterpillar Built Machines Flywheel - Remove and Install
C9.3 Engines for Caterpillar Built Machines Engine Top Speed Is Not Obtained
C13 Engine for Caterpillar Built Machines Alternator - Remove and Install
Quick Start Guide for Manual Paralleling{7451} Quick Start Guide for Manual Paralleling{7451}
C7.1 Industrial Engine Model View Illustrations
C13, C15, and C18 Tier 4 Interim Engines Exhaust Has Excessive White Smoke
C13 Engine for Caterpillar Built Machines Refrigerant Compressor - Remove and Install
2009/04/13 An Improved PL1000E Electronic Control Module Is Now Used {7610}
C13 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
2009/04/06 New Springs Are Now Used on CX31 On-Highway Transmission {3155}
C15 and C18 Engines for Caterpillar Built Machines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install