Flywheel Housing - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7574 | Link Brackets | 2 |
B | 8C-8422 | Sealant | - |
Start By:
- Remove the flywheel.
- Remove the crankshaft rear seal.
- Remove fuel filter base (1) and reposition fuel filter base (1). Remove bracket (2).
Show/hide table
Illustration 2 g01870417 - Remove oil filter base (3) and reposition oil filter base (3). Remove bracket (4).
Show/hide table
Illustration 3 g01870418 - Install Tooling (A) and a suitable lifting device to flywheel housing (6). The weight of flywheel housing (6) is approximately
64 kg (140 lb) . Remove bolts (5) and flywheel housing (6).
Show/hide table
Illustration 1 | g02175589 |
- Install flywheel housing (6) in reverse order of removal.
- Apply Tooling (B) to flywheel housing (6).
Caterpillar Information System:
C9.3 Engines for Caterpillar Built Machines Symptom Troubleshooting
C7.1 Industrial Engine and Generator Set ECM Memory - Test
C15 and C18 Engines for Caterpillar Built Machines Belt Tensioner - Remove and Install
C12 Marine Engines Engine and Marine Transmission Operation
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0271 - FMI 03
C13, C15, and C18 Tier 4 Interim Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Cooling Fan Is Always ON
C6.6 Industrial Engine Starter Motor
C6.6 Industrial Engine Engine Oil Pressure
C9.3 Engines for Caterpillar Built Machines Valve Lash Is Excessive
C9.3 Engines for Caterpillar Built Machines Engine Has Mechanical Noise (Knock)
C13, C15, and C18 Tier 4 Interim Engines Engine Overspeeds
2009/04/13 Procedure to Install the Muffler Bracket on Weatherproof Generator Set Enclosures and Improved Sealing of the Enclosures {0649, 1062}
2009/04/06 A New Paint Scheme Is Used on C7 through C32 Marine Engines with the Pleasurecraft Finish {1000, 7559, 7581}
Installation and Maintenance of the Microfilter for Natural Gas {1261} Installation and Maintenance of the Microfilter for Natural Gas {1261}
C13 Engine for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Crankcase Pressure Is High
C13 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Engine Stalls at Low RPM
C13 Engines for Caterpillar Built Machines Flywheel - Remove and Install
C9.3 Engines for Caterpillar Built Machines Engine Top Speed Is Not Obtained
C13 Engine for Caterpillar Built Machines Alternator - Remove and Install
Quick Start Guide for Manual Paralleling{7451} Quick Start Guide for Manual Paralleling{7451}