Flywheel - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | FT2712 | Guide Stud | 2 |
B | 7M-7456 | Bearing Mount Compound | - |
- Remove two of bolts (1) and install Tooling (A).
- Use two people to remove flywheel (2). The weight of flywheel (2) is approximately
41 kg (90 lb) . Remove remaining bolts (1) and flywheel (2). - Use a hammer and a punch to remove the ring gear.
Show/hide table
Illustration 1 | g01871015 |
- Install flywheel (2) in reverse order of removal.
- Raise the temperature of the ring gear. Use a soft hammer to seat the ring gear on the flywheel.
- Apply Tooling (B) to the threads of bolts (1).
- Tighten bolts (1) to a torque of
300 ± 40 N·m (221 ± 30 lb ft) .
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
Caterpillar Information System:
C13, C15, and C18 Tier 4 Interim Engines Engine Stalls at Low RPM
C13 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Crankcase Pressure Is High
C13 Engine for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
Installation and Maintenance of the Microfilter for Natural Gas {1261} Installation and Maintenance of the Microfilter for Natural Gas {1261}
2009/04/06 A New Paint Scheme Is Used on C7 through C32 Marine Engines with the Pleasurecraft Finish {1000, 7559, 7581}
2009/04/13 Procedure to Install the Muffler Bracket on Weatherproof Generator Set Enclosures and Improved Sealing of the Enclosures {0649, 1062}
C13, C15, and C18 Tier 4 Interim Engines Engine Overspeeds
C13 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C9.3 Engines for Caterpillar Built Machines Symptom Troubleshooting
C7.1 Industrial Engine and Generator Set ECM Memory - Test
C15 and C18 Engines for Caterpillar Built Machines Belt Tensioner - Remove and Install
C9.3 Engines for Caterpillar Built Machines Engine Top Speed Is Not Obtained
C13 Engine for Caterpillar Built Machines Alternator - Remove and Install
Quick Start Guide for Manual Paralleling{7451} Quick Start Guide for Manual Paralleling{7451}
C7.1 Industrial Engine Model View Illustrations
C13, C15, and C18 Tier 4 Interim Engines Exhaust Has Excessive White Smoke
C13 Engine for Caterpillar Built Machines Refrigerant Compressor - Remove and Install
2009/04/13 An Improved PL1000E Electronic Control Module Is Now Used {7610}
C13 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
2009/04/06 New Springs Are Now Used on CX31 On-Highway Transmission {3155}
C15 and C18 Engines for Caterpillar Built Machines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Solenoid Valve (Exhaust Balance) - Remove and Install
C13 Engines for Caterpillar Built Machines Front Cover - Remove and Install