Accessory Drive - Disassemble
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 8H-0663 | 轴承拉拔器 | 1 |
| 5F-7345 | 拉拔器 | 1 | |
| 126-7183 | 十字挡块 | 1 | |
| 126-7177 | 拉拔器腿 | 2 | |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
| 注意 |
|---|
|
在检验、保养、测试、调整及维修产品时，务必留心，确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前，要准备好用合适的容器收集液体。 按照本地法规和指令处置所有液体。 |
- 从附件驱动壳体 (4) 上卸下簧环 (9)。
- 将附件驱动壳体 (4) 放在适当的支架上。 将齿轮 (7)、轴承 (6) 和轴承 (8) 的组件从附件驱动壳体 (4) 中按压出来。
- 使用工具 (A)，从齿轮 (7) 上卸下轴承 (6) 和轴承 (8)。
Show/hide table
| |
| 图 1 | g01440573 |
|
典型实例 | |
Caterpillar Information System:
C4.4 Industrial Engine Accessory Drive - Remove
345D, 349D and 349D2 Excavators Hydraulic System Travel on Level Ground - Test - Optional Test
C11 and C13 Petroleum Engines Accessory Drive - Install
345D, 349D and 349D2 Excavators Hydraulic System Engine Performance - Test - Engine Speed
C11 and C13 Petroleum Engines Accessory Drive - Remove
Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467} Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467}
Software Update for Model Year 2007 C7 On-Highway Engine in General Motor Chassis{1901} Software Update for Model Year 2007 C7 On-Highway Engine in General Motor Chassis{1901}
C11 and C13 Petroleum Engines Flywheel Housing - Remove and Install
2008/03/24 New Check Valves are Now Used on the Oscillating Axle on Excavators {5468}
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Install
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Remove
C11 and C13 Petroleum Engines Flywheel - Install
C4.4 Industrial Engine Accessory Drive - Assemble
C4.4 Industrial Engine Accessory Drive - Install
Procedure for Cleaning Ash from the Diesel Particulate Filter (DPF) for Certain Caterpillar Engines{108F, 1091} Procedure for Cleaning Ash from the Diesel Particulate Filter (DPF) for Certain Caterpillar Engines{108F, 1091}
Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091} Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091}
C9 Marine Auxiliary and Generator Set Engines Configuration Parameters
G3500B Engines Water Temperature Regulator
C13T-TH35 and C15T-TH35 Petroleum Packages Plate Locations and Film Locations
2008/02/11 The Wiring Harness for the Turbocharger Compressor Outlet Pressure Sensor has been Rerouted {1403, 1408, 1917}
345D, 349D and 349D2 Excavators Hydraulic System Travel on Level Ground - Test
345D, 349D and 349D2 Excavators Hydraulic System Swing Speed and Swing Drift on a Slope - Check
C11 and C13 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C15 On-Highway Engine Diesel Particulate Filter - Disassemble