Accessory Drive - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
C | 1U-6396 | O 形圈组装固定胶 | 1 |
D | 4C-4030 | 螺纹锁固胶 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 检查前壳体 (3) 中的孔是否损坏。 如有必要,更换前壳体。 请参阅拆解和组装 , "壳体(前)- 拆卸"和拆解和组装 , "壳体(前)- 安装"。
- 使用工具 (C) 轻轻地润滑新的 O 形密封圈 (5) (未显示)。 将 O 形密封圈(未显示)安装到附件驱动壳体 ( 4) 的槽中。
- 轻轻地用清洁的发动机润滑油润滑所有轴承和所有的齿轮。 将附件驱动组件安装到前壳体上。 确保附件驱动壳体上的法兰与前壳体齐平。
- 将工具 (D) 涂敷到六角螺钉 ( 1) 和六角螺钉 (2)上。
- 将六角螺钉 (1) 和 ( 2) 安装到附件驱动壳体 ( 4) 上。
- 拧紧六角螺钉 (1) 至扭矩为
22 N·m (16 lb ft) 。拧紧六角螺钉 (2) 至扭矩为
44 N·m (32 lb ft) 。 依次拧紧图 2 所示的六角螺钉 ( 1) 和 (2)。 - 确保惰轮与附件驱动齿轮之间有足够齿隙。
Show/hide table
图 1 | g01441026 |
典型实例 |
Show/hide table
图 2 | g01444555 |
附件驱动的拧紧顺序 |
Caterpillar Information System:
C4.4 Industrial Engine Accessory Drive - Assemble
C4.4 Industrial Engine Accessory Drive - Disassemble
C4.4 Industrial Engine Accessory Drive - Remove
345D, 349D and 349D2 Excavators Hydraulic System Travel on Level Ground - Test - Optional Test
C11 and C13 Petroleum Engines Accessory Drive - Install
345D, 349D and 349D2 Excavators Hydraulic System Engine Performance - Test - Engine Speed
C11 and C13 Petroleum Engines Accessory Drive - Remove
Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467} Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467}
Software Update for Model Year 2007 C7 On-Highway Engine in General Motor Chassis{1901} Software Update for Model Year 2007 C7 On-Highway Engine in General Motor Chassis{1901}
C11 and C13 Petroleum Engines Flywheel Housing - Remove and Install
2008/03/24 New Check Valves are Now Used on the Oscillating Axle on Excavators {5468}
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Install
Procedure for Cleaning Ash from the Diesel Particulate Filter (DPF) for Certain Caterpillar Engines{108F, 1091} Procedure for Cleaning Ash from the Diesel Particulate Filter (DPF) for Certain Caterpillar Engines{108F, 1091}
Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091} Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091}
C9 Marine Auxiliary and Generator Set Engines Configuration Parameters
G3500B Engines Water Temperature Regulator
C13T-TH35 and C15T-TH35 Petroleum Packages Plate Locations and Film Locations
2008/02/11 The Wiring Harness for the Turbocharger Compressor Outlet Pressure Sensor has been Rerouted {1403, 1408, 1917}
345D, 349D and 349D2 Excavators Hydraulic System Travel on Level Ground - Test
345D, 349D and 349D2 Excavators Hydraulic System Swing Speed and Swing Drift on a Slope - Check
C11 and C13 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C15 On-Highway Engine Diesel Particulate Filter - Disassemble
345D, 349D and 349D2 Excavators Hydraulic System Cylinder Speed - Check
C15 On-Highway Engine Diesel Particulate Filter - Assemble