Flywheel - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7574 | Link Bracket | 1 |
B | FT2712 | Guide Stud | 1 |
- Raise the temperature of the ring gear. Position the ring gear with the part number toward the crankshaft. Install the ring gear on the flywheel. Allow the ring gear to cool. Use a soft hammer in order to seat the ring gear against the shoulder of the flywheel.
Show/hide table
Illustration 1 g01453454 - Attach Tooling (A) and a suitable lifting device to flywheel (1). The weight of flywheel (1) is approximately
50 kg (110 lb) . - Position flywheel (1) on Tooling (B).
- Install bolts (2). Remove Tooling (B). Install remaining bolt (2). Tighten the bolts evenly to a torque of
300 ± 40 N·m (221 ± 30 lb ft) . - Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect" for the correct procedure.
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
Caterpillar Information System:
C13 and C15 Engines for Combat and Tactical Vehicles Air Inlet Shutoff Circuit - Test
C11 and C13 Petroleum Engines Flywheel - Remove
2008/07/21 Improved Fuel Injection Pump {1251, 1714}
C11 and C13 Petroleum Engines Water Temperature Regulator - Remove and Install
C11 and C13 Petroleum Engines Water Pump - Install
2008/04/21 Improved Exhaust Risers and Brackets are Now Used {1059}
2008/02/11 Use of Remanufactured Injectors in Marine Engines {1290}
C11 and C13 Petroleum Engines Water Pump - Remove
A New Purge Pump and Service Pack are Now Used{107P} A New Purge Pump and Service Pack are Now Used{107P}
2008/04/14 New Processes Improve Registration of Product Link {7338, 7606}
C11 and C13 Petroleum Engines Engine Oil Cooler - Install
C18 Industrial Engines Speed Sensor - Clean/Inspect
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Remove
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Install
2008/03/24 New Check Valves are Now Used on the Oscillating Axle on Excavators {5468}
C11 and C13 Petroleum Engines Flywheel Housing - Remove and Install
Software Update for Model Year 2007 C7 On-Highway Engine in General Motor Chassis{1901} Software Update for Model Year 2007 C7 On-Highway Engine in General Motor Chassis{1901}
Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467} Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467}
C11 and C13 Petroleum Engines Accessory Drive - Remove
345D, 349D and 349D2 Excavators Hydraulic System Engine Performance - Test - Engine Speed
C11 and C13 Petroleum Engines Accessory Drive - Install
345D, 349D and 349D2 Excavators Hydraulic System Travel on Level Ground - Test - Optional Test
C4.4 Industrial Engine Accessory Drive - Remove
C4.4 Industrial Engine Accessory Drive - Disassemble