Water Pump - Remove
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Show/hide table
Illustration 1 g01453211 - Remove bolts (1).
- Remove housing (2).
Show/hide table
Illustration 2 g01453212 - Remove tube assembly (3) and tube assembly (4).
- Remove bolts (6).
- Remove water pump (5).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Caterpillar Information System:
A New Purge Pump and Service Pack are Now Used{107P} A New Purge Pump and Service Pack are Now Used{107P}
2008/04/14 New Processes Improve Registration of Product Link {7338, 7606}
C11 and C13 Petroleum Engines Engine Oil Cooler - Install
C18 Industrial Engines Speed Sensor - Clean/Inspect
Downloading Programs to Power Generation Equipment with the Execloader Software{7620} Downloading Programs to Power Generation Equipment with the Execloader Software{7620}
C11 and C13 Petroleum Engines Engine Oil Cooler - Remove
C11 and C13 Petroleum Engines Exhaust Manifold - Remove and Install
Seizure of Thermocouple Threads in Some G3500C and G3500E Exhaust Manifolds{1408, 1900, 7498} Seizure of Thermocouple Threads in Some G3500C and G3500E Exhaust Manifolds{1408, 1900, 7498}
2008/05/19 Improved Oil Return Lines for the Turbocharger are Used {1052, 1307}
C11 and C13 Petroleum Engines Turbocharger - Install
2008/04/01 New Mounting for the Temperature Sensor Is Now Used {108B, 108E, 108M}
2008/03/01 A New Spring Guide for the Camshaft Lifter is Used {1209}
2008/02/11 Use of Remanufactured Injectors in Marine Engines {1290}
2008/04/21 Improved Exhaust Risers and Brackets are Now Used {1059}
C11 and C13 Petroleum Engines Water Pump - Install
C11 and C13 Petroleum Engines Water Temperature Regulator - Remove and Install
2008/07/21 Improved Fuel Injection Pump {1251, 1714}
C11 and C13 Petroleum Engines Flywheel - Remove
C13 and C15 Engines for Combat and Tactical Vehicles Air Inlet Shutoff Circuit - Test
C11 and C13 Petroleum Engines Flywheel - Install
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Remove
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Install
2008/03/24 New Check Valves are Now Used on the Oscillating Axle on Excavators {5468}
C11 and C13 Petroleum Engines Flywheel Housing - Remove and Install