Engine Oil Cooler - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Attach a suitable lifting device to engine oil cooler (2). The weight of engine oil cooler (2) is approximately
23 kg (50 lb) . - Position engine oil cooler (2) on the engine.
- Connect bonnet (1).
- Install bonnet (3).
- Install bolts (5) and (6).
- Connect hose (4).
- Fill the coolant system. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Show/hide table
Illustration 1 | g01453050 |
Caterpillar Information System:
C18 Industrial Engines Speed Sensor - Clean/Inspect
Downloading Programs to Power Generation Equipment with the Execloader Software{7620} Downloading Programs to Power Generation Equipment with the Execloader Software{7620}
C11 and C13 Petroleum Engines Engine Oil Cooler - Remove
C11 and C13 Petroleum Engines Exhaust Manifold - Remove and Install
Seizure of Thermocouple Threads in Some G3500C and G3500E Exhaust Manifolds{1408, 1900, 7498} Seizure of Thermocouple Threads in Some G3500C and G3500E Exhaust Manifolds{1408, 1900, 7498}
2008/05/19 Improved Oil Return Lines for the Turbocharger are Used {1052, 1307}
C11 and C13 Petroleum Engines Turbocharger - Install
2008/04/01 New Mounting for the Temperature Sensor Is Now Used {108B, 108E, 108M}
2008/03/01 A New Spring Guide for the Camshaft Lifter is Used {1209}
C7 Petroleum Engines Cooling System - Check - Overheating
C11 and C13 Petroleum Engines Turbocharger - Remove
C11 and C13 Petroleum Engines Fuel Filter Base - Install
2008/04/14 New Processes Improve Registration of Product Link {7338, 7606}
A New Purge Pump and Service Pack are Now Used{107P} A New Purge Pump and Service Pack are Now Used{107P}
C11 and C13 Petroleum Engines Water Pump - Remove
2008/02/11 Use of Remanufactured Injectors in Marine Engines {1290}
2008/04/21 Improved Exhaust Risers and Brackets are Now Used {1059}
C11 and C13 Petroleum Engines Water Pump - Install
C11 and C13 Petroleum Engines Water Temperature Regulator - Remove and Install
2008/07/21 Improved Fuel Injection Pump {1251, 1714}
C11 and C13 Petroleum Engines Flywheel - Remove
C13 and C15 Engines for Combat and Tactical Vehicles Air Inlet Shutoff Circuit - Test
C11 and C13 Petroleum Engines Flywheel - Install
C11 and C13 Petroleum Engines Crankshaft Rear Seal - Remove