Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 1P-0510 | Driver Gp | 1 |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Note: Check the O-ring seals for wear or for damage. Replace the components, if necessary.
- Use Tooling (A) in order to install sleeve bearings (18).
Note: Be sure to install sleeve bearings (18) to a depth of Dimension (Y). The joints on sleeve bearings (18) must be installed to the angle of Dimension (X).
Show/hide tableIllustration 3 g01412797 - Install O-ring seal (17) and install gear assembly (16).
Show/hide table
Illustration 4 g01412794 - Install key (15).
Show/hide table
Illustration 5 g01412788 - Install gears (14).
Show/hide table
Illustration 6 g01412784 - Install body (13). Install shaft (11) and gear (12).
Show/hide table
Illustration 7 g01412697 Show/hide tableIllustration 8 g01412937 (Y) 1.50 ± 0.50 mm (0.059 ± 0.020 inch)
(X) 30 degrees - Use Tooling (A) in order to install sleeve bearings (10) to cover assembly (8).
Note: Be sure to install sleeve bearings (10) to a depth of Dimension (Y). The joints on sleeve bearings (10) must be installed to the angle of Dimension (X).
- Install O-ring seal (9) to cover assembly (8).
Show/hide table
Illustration 9 g01412657 - Position cover assembly (8) and install bolt (7).
Show/hide table
Illustration 10 g01412736 - Install O-ring seal (6) and O-ring seal (5) to manifold assembly (3).
Show/hide table
Illustration 11 g01412719 - Position manifold assembly (3) and install bolts (2). Install O-ring seal (4) and install O-ring seal (1).
Illustration 1 | g01412811 |
Illustration 2 | g01412858 |
(Y) (X) 30 degrees |
End By:
- Install the gear pump. Refer to Disassembly and Assembly, "Gear Pump (Transmission Charging and Scavenge - Install".