C27 and C32 Generator Sets and C32 Power Module Return Fuel Lines{1274} Caterpillar


C27 and C32 Generator Sets and C32 Power Module Return Fuel Lines{1274}

Usage:

C27 DWB
Generator Set:
C27 GEN SET (S/N: DWB108-606)
C32 GEN SET (S/N: SXC632-1894)
Power Module:
C32 POWER MODUL (S/N: MED100-163)

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem

Caterpillar has recently experienced failures of the return fuel lines on C27 and C32 Generator Sets and C32 Power Module. The failures occurred when the units were operating at 90% to 100% load factor in an enclosed environment. The affected serial numbers are listed above.

Solution

Caterpillar recommends these power modules and enclosed units be operated at no more than 60% load until new fuel lines are installed. A service letter will be released by 27August 2007 in order to rework the return fuel lines.

Caterpillar Information System:

G3408 and G3412 Engines Governor
3500 Generator Sets Emergency Stopping
Copper Contamination of the Engine Oil in some 3500C Marine Engines{1000, 1348} Copper Contamination of the Engine Oil in some 3500C Marine Engines{1000, 1348}
3500 Generator Sets Air Shutoff - Test - Engines That Are Equipped with ADEM II or ADEM III Engine Control Modules (If equipped)
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Log File Messages
PM3500 Power Modules Overhaul Considerations
14L Motor Grader Gear Pump (Transmission Charging and Scavenge) - Assemble
G3408C and G3412C Engines Piston and Rings - Gallery Cooled Piston
C18 Power Module Before Starting Engine
14L Motor Grader Gear Pump (Transmission Charging and Scavenge) - Disassemble
C3.4 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
C7 Engines for Caterpillar Built Machines Engine Oil Pump - Inspect
Remanufactured 3126 Cylinder Heads with Incorrect Valve Seats{1100} Remanufactured 3126 Cylinder Heads with Incorrect Valve Seats{1100}
14L Motor Grader Machine Systems Blade Lift Arm - Remove
14L Motor Grader Machine Systems Blade Lift Arm - Install
3500B Locomotive Engines Overspeed Verification Test
Replacing Low Pressure Actuator Valves{1130} Replacing Low Pressure Actuator Valves{1130}
C15 and C18 Petrolem Generator Set Engines Electrical Power Supply - Test
G3520B Engines Pressure Switch (Hydrax)
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Cylinder Head - Inspect
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines General Information
G3408C and G3412C Engines Air Cleaner
PL1000E Communication ECM Modbus Master
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.