Cylinder Head - Inspect
Show/hide table
Required Tools | ||
---|---|---|
Part Number | Part Name | Qty |
8S-6691 | Cylinder Head Stand Set | 1 |
Show/hide table
Illustration 1 | g01112400 |
Bolt tightening sequence for the C0.5, engine |
Show/hide table
Illustration 2 | g00907442 |
Bolt tightening sequence for the C0.7, C1.1, and C1.5 engines |
Show/hide table
Illustration 3 | g00907444 |
Bolt tightening sequence for the C1.6, C2.2 and C2.2T engine |
- Remove the bolts in the cylinder head in the reverse sequence that is shown in Illustrations 1, 2 and 3.
Remove the cylinder head from the engine.
- Clean the cylinder head thoroughly. Make sure that the contact surface of the cylinder head and the contact surface of the cylinder block are clean, smooth, and flat.
- Inspect the bottom surface of the cylinder head for pitting, corrosion, and cracks. Inspect the area around the valve seats and the holes for the fuel injection nozzles.
Show/hide table
Illustration 4 g00842292 Typical example - Put cylinder head (1) on the 8S-6691 Cylinder Head Stand Set (2).
Show/hide table
Illustration 5 g00907448 Typical example - Use a straight edge and a feeler gauge to check the six positions of the cylinder head for distortion. Refer to Specifications, "Cylinder Head" for the requirements of flatness.
Caterpillar Information System:
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
G3520B Engines Pressure Switch (Hydrax)
C15 and C18 Petrolem Generator Set Engines Electrical Power Supply - Test
Replacing Low Pressure Actuator Valves{1130} Replacing Low Pressure Actuator Valves{1130}
3500B Locomotive Engines Overspeed Verification Test
14L Motor Grader Machine Systems Blade Lift Arm - Install
14L Motor Grader Machine Systems Blade Lift Arm - Remove
Remanufactured 3126 Cylinder Heads with Incorrect Valve Seats{1100} Remanufactured 3126 Cylinder Heads with Incorrect Valve Seats{1100}
C27 and C32 Generator Sets and C32 Power Module Return Fuel Lines{1274} C27 and C32 Generator Sets and C32 Power Module Return Fuel Lines{1274}
G3408 and G3412 Engines Governor
3500 Generator Sets Emergency Stopping
Copper Contamination of the Engine Oil in some 3500C Marine Engines{1000, 1348} Copper Contamination of the Engine Oil in some 3500C Marine Engines{1000, 1348}
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines General Information
G3408C and G3412C Engines Air Cleaner
PL1000E Communication ECM Modbus Master
C32 Marine Engine Model View Illustrations
C32 Marine Engine Safety Messages
G3408C and G3412C Engines Gas Engine Ignition
C32 Marine Engine Plate Locations and Film Locations
3500B Engines Fan - Remove and Install
G3500B Engines Jacket Water Temperature Sensor
3500B Engines Fuel Cooler - Remove and Install
G3408C and G3412C Engines Carburetor
325D and 329D Excavators Hydraulic System Cylinder Drift - Check - Empty Bucket