Turbocharger
Show/hide table
| |
| Illustration 1 | g01391853 |
(1) Turbocharger clamps
Use the following procedure to tighten the clamps.
- Tighten the turbocharger clamps.
Torque ...
14.0 ± 1.5 N·m (10 ± 1 lb ft) - Gently hit around the turbocharger clamps with a soft faced hammer.
- Again tighten the turbocharger clamps.
Torque ...
14.0 ± 1.5 N·m (10 ± 1 lb ft)
Caterpillar Information System:
C15 and C18 Generator Set Engines Expansion Tank - Remove and Install
3512C Industrial Engine Flywheel Housing - Install
Bench Test Procedure For A TH31-E61 Oil/Gas Transmission With A Drop Box {3030} Bench Test Procedure For A TH31-E61 Oil/Gas Transmission With A Drop Box {3030}
3512C Industrial Engine Accessory Drive (Front) - Remove
3512C Industrial Engine Alternator - Remove and Install
3512C Industrial Engine Cylinder Head - Remove
C15 and C18 Generator Set Engines Fuel Cooler - Remove and Install
G3500 A3 Engines Engine Coolant Temperature (High)
2007/06/25 New Pressure Sensors are Used {1000, 1408, 1900}
Missing Pipe Plugs on the C-10, C-12, C-15, C15, and C-16 Engines Jake Brake{1119} Missing Pipe Plugs on the C-10, C-12, C-15, C15, and C-16 Engines Jake Brake{1119}
3512C Industrial Engine Flywheel - Remove and Install
C4.4 (Mech) Industrial Engine Engine Valve Lash - Inspect/Adjust
G3500 A3 Engines Exhaust Manifold - Water cooled
G3508, G3512 and G3516 Engines Nitrogen Oxide Sensor - Remove and Install
2007/07/02 A New Spark Plug is Available {1550, 1555}
G3300 Engines Product Storage
C7 Petroleum Engine Speed Sensor - Clean/Inspect
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Cooling System Coolant Sample (Level 2) - Obtain
C15 Petroleum Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
C4.4 Industrial Engine Fuel Related Components in Cold Weather
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Governor - Adjust
C6.6 Industrial Engine Refill Capacities and Recommendations
C7.1 (Mech) Industrial Engine Alternator - Inspect
G3500 A3 Engines Fuel Energy Content