Engine Oil Pressure Sensor
Show/hide table
图 1 | g01502573 |
(1) 压力传感器总成的最终安装扭矩 ... 10 ± 2 N·m (90 ± 18 lb in)
工作温度 ... −40 到 125 °C (−40 到 257 °F)
工作电压 ... 5.0 ± 0.5 VDC
Caterpillar Information System:
CX35 On-Highway Transmission Pump Drive - Install - Rear PTO shaft
C13, C15, and C18 Tier 4 Final Engines Coolant Temperature Sensor
CX35 On-Highway Transmission Pump Drive - Remove - Rear PTO Shaft
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Maintenance Interval Schedule
C4.4 (Mech) Industrial Engine Alternator - Inspect
C18 Marine Auxiliary Engines Speed/Timing - Test
C4.4 (Mech) Industrial Engine After Stopping Engine
C4.4 (Mech) Industrial Engine Before Starting Engine
C4.4 (Mech) Industrial Engine Before Starting Engine
C9 On-highway Engine Water Temperature Regulator Housing
C4.4 (Mech) Industrial Engine Engine Shutoffs and Engine Alarms
C4.4 (Mech) Industrial Engine Fuel Shutoff
C11 and C13 Petroleum Engines Cylinder Block
C6.6 Industrial Engine Boost Pressure Sensor
C9 On-highway Engine Inlet Manifold - Remove
3508C, 3512C and 3516C Marine Engines Fumes Filter - Remove and Install
C4.4 (Mech) Industrial Engine Hoses and Clamps - Inspect/Replace
C4.4 (Mech) Industrial Engine General Hazard Information
C4.4 (Mech) Industrial Engine Maintenance Log
C4.4 (Mech) Industrial Engine Fuel Related Components in Cold Weather
C9 On-highway Engine Inlet Manifold - Install
C175-16 Locomotive Engine Fuel Pressure Sensor
C11 and C13 Engines Fuel Temperature Sensor
C9 On-highway Engine Engine Control Module - Remove and Install