Boost Pressure Sensor
Show/hide table
图 1 | g01502573 |
(1) 压力传感器总成的最终安装扭矩 ... 10 ± 2 N·m (90 ± 18 lb in)
工作温度 ... −40 至 125 °C (−40 至 257 °F)
工作电压 ... 5.0 ± 0.5 VDC
Caterpillar Information System:
C11 and C13 Petroleum Engines Cylinder Block
C4.4 Industrial Engine Engine Oil Pressure Sensor
CX35 On-Highway Transmission Pump Drive - Install - Rear PTO shaft
C13, C15, and C18 Tier 4 Final Engines Coolant Temperature Sensor
CX35 On-Highway Transmission Pump Drive - Remove - Rear PTO Shaft
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Maintenance Interval Schedule
C4.4 (Mech) Industrial Engine Alternator - Inspect
C18 Marine Auxiliary Engines Speed/Timing - Test
C4.4 (Mech) Industrial Engine After Stopping Engine
C4.4 (Mech) Industrial Engine Before Starting Engine
C4.4 (Mech) Industrial Engine Before Starting Engine
C9 On-highway Engine Water Temperature Regulator Housing
C9 On-highway Engine Inlet Manifold - Remove
3508C, 3512C and 3516C Marine Engines Fumes Filter - Remove and Install
C4.4 (Mech) Industrial Engine Hoses and Clamps - Inspect/Replace
C4.4 (Mech) Industrial Engine General Hazard Information
C4.4 (Mech) Industrial Engine Maintenance Log
C4.4 (Mech) Industrial Engine Fuel Related Components in Cold Weather
C9 On-highway Engine Inlet Manifold - Install
C175-16 Locomotive Engine Fuel Pressure Sensor
C11 and C13 Engines Fuel Temperature Sensor
C9 On-highway Engine Engine Control Module - Remove and Install
2007/10/15 A New Coupling is Used {3252}
CX35 On-Highway Transmission Transmission and Torque Converter - Separate