Inlet Manifold - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 8C-8422     | Sealant     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply Tooling (A) in order to cover the joint face of starting aid (11) and the joint face of inlet manifold (3). Spread uniformly across starting aid (11) and inlet manifold (3). Starting aid (11) and inlet manifold (3) must be installed and tightened within ten minutes of applying Tooling (A) .
Show/hide table
Illustration 1 | g01357058 |
Show/hide table
Illustration 2 | g01357028 |
- Install starting aid (11) and inlet manifold (3). Install bolts and studs (10) .
- Position bracket (9) and install nuts (8) .
- Connect cable assemblies (7) .
- Install tube assembly (1) .
Show/hide table
Illustration 3 | g01356983 |
- Position the harness assembly and connect harness assemblies (2) and (5). Install new cable straps (4) .
- Install nuts (6) .
- Connect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Connect".
End By: Install the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install".
Caterpillar Information System:
C4.4 (Mech) Industrial Engine Fuel Related Components in Cold Weather
C4.4 (Mech) Industrial Engine Maintenance Log
C4.4 (Mech) Industrial Engine General Hazard Information
C4.4 (Mech) Industrial Engine Hoses and Clamps - Inspect/Replace
3508C, 3512C and 3516C Marine Engines Fumes Filter - Remove and Install
C9 On-highway Engine Inlet Manifold - Remove
C6.6 Industrial Engine Boost Pressure Sensor
C11 and C13 Petroleum Engines Cylinder Block
C4.4 Industrial Engine Engine Oil Pressure Sensor
CX35 On-Highway Transmission Pump Drive - Install - Rear PTO shaft
C13, C15, and C18 Tier 4 Final Engines Coolant Temperature Sensor
CX35 On-Highway Transmission Pump Drive - Remove - Rear PTO Shaft
C175-16 Locomotive Engine Fuel Pressure Sensor
C11 and C13 Engines Fuel Temperature Sensor
C9 On-highway Engine Engine Control Module - Remove and Install
2007/10/15 A New Coupling is Used {3252}
CX35 On-Highway Transmission Transmission and Torque Converter - Separate
C9 On-highway Engine Engine Oil Filter Base - Remove
CX35 On-Highway Transmission Transmission and Torque Converter - Connect
CX35 On-Highway Transmission Torque Converter Housing - Remove
CX35 On-Highway Transmission Torque Converter Housing - Install
C32 Marine Generator Set Gauges and Indicators
C18 Marine Auxiliary Engine Starting the Engine
C18 Marine Generator Set Cold Weather Starting