Check the Hydraulic Fan Pump on AD55B and AD60 Underground Articulated Trucks{1387, 5070} Caterpillar


Check the Hydraulic Fan Pump on AD55B and AD60 Underground Articulated Trucks{1387, 5070}

Usage:

AD55B JNW
Underground Articulated Truck:
AD55B (S/N: JNW1-UP)
AD60 (S/N: KNW1-UP)

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem




Illustration 1g03422496

(1) 293-9611 Piston Pump Gp

Field service reports indicate that 293-9611 Piston Pump Gp (1) may leak. Refer to Illustration 1.




Illustration 2g03422497

(1) 293-9611 Piston Pump Gp

(2) 168-3504 Seal

A leaking 293-9611 Piston Pump Gp (1) may be due to a failed 168-3504 Seal (2) .

Solution

In the event of a leaking 293-9611 Piston Pump Gp (1), check 168-3504 Seal (2) for failure. Replace a failed 168-3504 Seal (2) with 8T-9528 O-Ring Seal .

Additional information is needed to resolve this issue. If you have experienced a leaking 293-9611 Piston Pump Gp (1) due to a failed 168-3504 Seal (2), follow the instruction below.

  • Submit a Dealer Solution Network (DSN) ticket

  • Request that a Tier 1 representative, transfer your ticket to an available Tier 2 representative for Caterpillar Underground Mining - Base Machine

Caterpillar Information System:

3500 Engines Pistons and Connecting Rods - Remove
966M and 972M Wheel Loaders Bucket Linkage and Loader Cylinder Bearings - Lubricate
D10T2 Track-Type Tractor Machine Systems Refrigerant Condenser - Remove and Install
990K Wheel Loader and 844K Wheel Dozer Engine Supplement Fan Blade (Spider) - Remove and Install
D6N Track-Type Tractor Transmission Breather - Clean/Replace
D10T2 Track-Type Tractor Machine Systems Piston Pump (Fan Charge and Pilot Pressure) - Remove and Install
980H Wheel Loader Engine Supplement Refrigerant Compressor - Remove and Install
D6T Track-Type Tractor Track - Check/Adjust
621K, 623K, and 627K Wheel Tractor-Scrapers Systems Control Valve (Implement) - 621K and 627K
836K Landfill Compactor, 834K Wheel Dozer and 988K Wheel Loader C18 Engine Supplement Engine Oil Cooler - Remove and Install
D10T2 Track-Type Tractor Machine Systems Pilot Oil Accumulator - Remove and Install
901C, 902C and 903C Compact Wheel Loaders PowerTrain Differential (Standard) - Assemble
C7.1 Engines Flywheel Housing - Remove and Install - Standard Housing
D6N Track-Type Tractor TA2 Technical Inspection{0372, 1000, 7000, 753T, 7565} D6N Track-Type Tractor TA2 Technical Inspection{0372, 1000, 7000, 753T, 7565}
966M and 972M Wheel Loaders Backup Alarm - Test - If Equipped
D10T2 Track-Type Tractor Machine Systems Implement Control Valve - Disassemble
966M and 972M Wheel Loaders System Pressure Release
3500 Engines Pistons and Connecting Rods - Install
966H and 972H Wheel Loaders PowerTrain Carrier Bearing (Drive Shaft) - Remove and Install
980M Tier 3, 982M Tier 3 and 980L Tier 3 Wheel Loader Power Train Modulating Valve (Transmission Clutch) - Install
966M and 972M Wheel Loaders Capacities (Refill)
980M Tier 3, 982M Tier 3 and 980L Tier 3 Wheel Loader Power Train Modulating Valve (Transmission Clutch) - Remove
966H and 972H Wheel Loaders PowerTrain Drive Shaft (Center) - Remove and Install
966H and 972H Wheel Loaders PowerTrain Drive Shaft (Rear) - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.