Crankshaft Pulley
Show/hide table
| |
| Illustration 1 | g00915497 |
|
Typical example | |
Note: Lubricate the threads of the bolts with clean engine oil before installation.
(1) Tighten the three bolts for the crankshaft pulley to the following torque. ...
Note: Recheck the torque of the bolts (1) twice.
(2) Thrust block
(3) Crankshaft pulley
Caterpillar Information System:
3512B Oil Well Servicing Engine (ADEM III) Air Shutoff System
Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201} Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201}
C9 Generator Set Engine Muffler - Remove and Install
C7 On-highway Engine Engine Oil Pan
C9 Generator Set Engine Engine Enclosure Group - Install
C6.6 Engines for Caterpillar Built Machines Gear Group (Front)
C3.3 Industrial Engine Crankshaft Seals
C175 Generator Set Engines Connecting Rod Bearings - Remove and Install
2005/12/19 The New Low Gas Pressure Module is Now Available {1901}
2008/07/07 Coolant Sensor Installation Service Notes {5574}
2008/07/14 Coolant Level Sensor Installation Service Notes {5574}
3500 Locomotive Engines Pressure Gauge
C3.3 Industrial Engine Engine Lifting Bracket
C3.3 Industrial Engine Flywheel Housing
C3.3 Industrial Engine Flywheel
C3.3 Industrial Engine Piston Cooling Jet
C3.3 Industrial Engine Piston and Rings
C3.3 Industrial Engine Connecting Rod - For Use With Steel Crankshaft
C3.3 Industrial Engine Main Bearing Journal - Steel Crankshaft
C3.3 Industrial Engine Connecting Rod Bearing Journal - Steel Crankshaft
C9 Generator Set Engine Cooling System Package (Radiator, Aftercooler, Fuel Cooler) - Remove
EMCP3 Engine Setpoint Verification - Test
C7 Marine Engine Alternator and Regulator
C7 Marine Engine Alternator and Regulator